P3022high severityPowertrain
CVT Secondary Pulley Speed Sensor Circuit
on 2011 Audi A3 2.0L TDI I4 · FWD
What this code means
The secondary (output) pulley speed sensor in the CVT is malfunctioning.
Symptoms
- Check Engine Light
- Incorrect speed display
- Transmission ratio errors
- Harsh ratio changes
- Limp mode
- No speedometer reading
Common causes
- Faulty secondary speed sensor
- Damaged wiring
- Tone ring contamination
- Corroded connector
- Sensor air gap incorrect
Diagnostic steps
- Read secondary pulley speed PID
- Test sensor resistance
- Inspect wiring and connector
- Check tone ring condition
- Compare to vehicle speed sensor
Repair notes
Replace secondary pulley speed sensor.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1