P3006moderate severityPowertrain
Variable Geometry Turbo (VGT) Actuator Position Sensor Circuit
on 2012 Audi A3 2.0L TDI I4 · FWD
What this code means
The variable geometry turbo vane position sensor is reporting values outside the expected range. The VGT system uses movable vanes to optimize boost across the RPM range.
Symptoms
- Check Engine Light
- Poor low-end torque
- Excessive smoke at low RPM
- Turbo surge or flutter
- Reduced fuel economy
Common causes
- VGT position sensor failure
- Carbon buildup on vane mechanism
- Actuator motor failure
- Corroded sensor connector
- Damaged wiring harness
Diagnostic steps
- Read VGT position PID on scan tool
- Command VGT vanes through full range with scan tool
- Inspect VGT actuator connector
- Test position sensor voltage range
- Check for carbon restriction on vanes
Repair notes
Replace VGT position sensor or actuator assembly. Clean carbon deposits from vane mechanism. Common on diesel vehicles.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1