P1415moderate severityPowertrain
Secondary Air System Bank 1
on 2007 BMW 325i 3.0L I6 N52 · RWD
What this code means
The DME detected a malfunction in the secondary air injection system for Bank 1. The secondary air system pumps fresh air into the exhaust manifold during cold starts to reduce hydrocarbon emissions.
Symptoms
- Check Engine Light
- Failed emissions test
- Rough cold start idle
- Unusual noise from air pump on startup
Common causes
- Faulty secondary air pump
- Secondary air valve stuck closed
- Clogged air passages in exhaust manifold
- Faulty secondary air pump relay
- Check valve failure
Diagnostic steps
- Listen for air pump operation during cold start
- Test air pump relay
- Check for voltage at air pump connector
- Inspect air passages for carbon blockage
- Test air pump by direct power application
Repair notes
Replace faulty secondary air pump or clean clogged air passages in the exhaust manifold.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1