P1682high severityPowertrain
Ignition 1 Switch Circuit 2 (Driver 5 Line 2)
on 2007 Cadillac SRX 3.6L V6 · AWD
What this code means
The PCM detected a voltage difference exceeding the maximum allowable threshold between the two circuits that supply it with battery voltage. This code is commonly caused by a failing ignition switch, which is a known issue on Trailblazer, Envoy, and SSR models among others.
Symptoms
- Check Engine Light
- Intermittent stalling
- Reduced Engine Power message
- Multiple warning lights
- Electrical accessories cutting out
- Intermittent no-start
Common causes
- Failed or failing ignition switch (most common)
- Defective fuse or fuse box
- Loose PCM power connector
- Corroded ignition switch connector
- Damaged wiring in ignition circuit
Diagnostic steps
- Test voltage at both PCM power supply circuits
- Compare voltage between the two circuits
- Inspect ignition switch connector
- Test ignition switch output under load
- Check all related fuses
Repair notes
Replace ignition switch (most common fix). Check fuses and connectors. This is a known issue on many GM trucks and SUVs, particularly Trailblazer, Envoy, and SSR.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1