C0091high severityChassis
Brake Booster Performance
on 2016 Mazda MX-5 Miata 2.0L I4 · RWD
What this code means
The brake booster is not providing adequate assist, detected by pressure sensor or pedal effort monitoring.
Symptoms
- Hard brake pedal
- Increased stopping distance
- Brake warning light on
- Engine may stall when brakes applied firmly
Common causes
- Leaking brake booster diaphragm
- Cracked or disconnected vacuum hose
- Check valve failure
- Brake booster control valve stuck
- Low engine vacuum on turbocharged vehicles
Diagnostic steps
- Perform brake booster leak-down test
- Check vacuum hose and check valve
- Test engine vacuum at idle
- Apply brakes with engine off then start engine (pedal should drop)
- Check booster operating rod adjustment
Repair notes
Replace brake booster if diaphragm is leaking. Replace vacuum hose or check valve as needed.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0026
RF Wheel Speed Sensor Circuit Intermittent
C0027
LR Wheel Speed Sensor Circuit Intermittent
C0028
RR Wheel Speed Sensor Circuit Intermittent
C0035
Left Front Wheel Speed Sensor Circuit
C0036
Left Front Wheel Speed Signal Erratic