2014 FORD F-250

6.2L V84WDAUTOMATICgas
5-Year Cost of Ownership
$14,688 maintenance + known platform issues
~$2,938/yr · 240¢/mile equivalent · $5,159 maintenance + $8,829 expected platform issues
Compare this engine
vs
6.7L V8 Power Stroke Diesel
vs
7.3L V8 Godzilla
Common Problems & Known Issues

The 2014 F-250 Super Duty represents a solid truck platform with the 6.2L gas being relatively trouble-free, but the 6.7L Power Stroke diesel had significant early-generation issues that were largely resolved in later years. This model year sits in the sweet spot after Ford worked out most of the 2011-2013 bugs.

6.7L Power Stroke CP4 Fuel Pump Failure (Catastrophic)

Occasional · high severity
Typical onset: 80,000-150,000 mi
Symptoms: Sudden loss of power and rough running, Metal contamination throughout entire fuel system, Fuel in oil (dilution), Check engine light with multiple fuel system codes
Fix: CP4 high-pressure fuel pump grenades internally, sending metal shavings through injectors, rails, lines, and tank. Requires complete fuel system replacement: pump, injectors (all 8), fuel rails, lines, tank cleaning or replacement, plus oil change. 20-30 hours labor depending on contamination level.
Estimated cost: $8,000-15,000

EGR Cooler Failure (Diesel Only)

Common · high severity
Typical onset: 60,000-120,000 mi
Symptoms: White smoke from exhaust, Coolant loss with no visible leaks, Overheating under load, Rough idle when cold, Steam from exhaust on cold starts
Fix: EGR cooler cracks internally, dumping coolant into exhaust side. Requires EGR cooler replacement and often EGR valve cleaning. Some techs delete the system in states where legal. 6-8 hours with cab-on, 4-5 if you pull the cab.
Estimated cost: $2,000-3,500

Transmission Oil Cooler Line Leaks

Common · medium severity
Typical onset: 70,000-130,000 mi
Symptoms: Transmission fluid spots under truck, Fluid on frame rails near radiator, Low transmission fluid level, Delayed engagement when low
Fix: Quick-connect fittings on cooler lines crack or corrode, causing leaks. Lines run from transmission to radiator-mounted cooler. Replace both lines as a set since if one fails, the other is close behind. 2-3 hours labor.
Estimated cost: $400-700

Turbocharger Actuator and Vane Sticking (Diesel)

Common · medium severity
Typical onset: 90,000-140,000 mi
Symptoms: Lack of power under acceleration, Black smoke on acceleration, Check engine light with turbo underboost codes (P0299, P003A), Surging or inconsistent boost, Turbo whine or whistle changes
Fix: Variable geometry turbo vanes stick from carbon buildup, or electronic actuator fails. Can sometimes be cleaned if caught early, but usually requires turbo replacement or rebuild. 6-8 hours labor to remove and replace.
Estimated cost: $1,800-3,200

Cab Mount Deterioration

Occasional · low severity
Typical onset: 100,000-150,000 mi
Symptoms: Clunking over bumps from cab area, Visible gaps between cab and frame changing size, Squeaking from cab mounts, Door alignment issues
Fix: Rubber cab mounts compress and deteriorate, especially in rust belt or heavy-use trucks. Requires lifting cab slightly to replace mounts. 4-6 hours for all four mounts.
Estimated cost: $600-1,200

Diesel Exhaust Fluid (DEF) System Issues

Occasional · medium severity
Symptoms: DEF system fault messages, Speed limited to 55 mph after warnings, Poor DEF mileage (using too much), Check engine light with NOx sensor codes, Crystallization around DEF fill neck
Fix: DEF heater, pump, injector, or quality sensor failures. Often caused by contaminated DEF or letting tank run completely dry. Diagnosis takes 1-2 hours; repairs range from simple sensor replacement (2 hours) to full pump module (4-5 hours).
Estimated cost: $500-2,500

Front Hub Bearing Assemblies

Occasional · medium severity
Typical onset: 80,000-120,000 mi
Symptoms: Grinding or humming noise that increases with speed, Noise changes when turning (louder on one side), Vibration through steering wheel, ABS or traction control light if sensor damaged
Fix: Heavy-duty application wears unit bearings, especially with oversized tires or heavy loads. Straightforward replacement but requires hub socket and considerable torque. 2-3 hours per side.
Estimated cost: $400-700
Owner tips
  • Diesel owners: Install an aftermarket CP4 bypass kit ($400-600) to protect the fuel system from catastrophic pump failure—cheap insurance against a $10k+ repair
  • Use only TOP TIER diesel fuel and change fuel filters religiously at 10,000 mile intervals on the 6.7L—fuel quality is everything for the CP4 pump
  • Never let the DEF tank run completely empty; refill at 1/4 tank to prevent pump and system damage
  • If you idle the diesel extensively (more than 30% of runtime), cut your oil change interval in half—these engines hate excessive idling
  • The 6.2L gas V8 is far simpler and more reliable if you don't need the towing capacity—seriously consider it for light-duty use
Buy the 6.2L gas without hesitation; the 6.7L diesel is capable but requires deep pockets for the inevitable CP4 failure—budget $10k in reserves or add a bypass kit immediately.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
520 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →