P3008low severityPowertrain
Turbo/Supercharger Bypass Valve Control Circuit
on 2013 Audi A6 3.0L Supercharged V6 · AWD
What this code means
The turbo bypass valve (diverter valve/blow-off valve) control circuit has a malfunction. The bypass valve recirculates pressurized air during throttle closure.
Symptoms
- Check Engine Light
- Compressor surge on deceleration
- Flutter noise from turbo
- Reduced boost response after throttle lift
- Check Engine Light after spirited driving
Common causes
- Faulty bypass valve solenoid
- Torn bypass valve diaphragm
- Wiring issue to solenoid
- Vacuum line leak
- PCM driver failure
Diagnostic steps
- Test bypass valve solenoid resistance
- Inspect vacuum lines to bypass valve
- Command solenoid with scan tool
- Check valve diaphragm for tears
- Inspect wiring and connector
Repair notes
Replace bypass valve or solenoid. Inspect vacuum hoses for cracks.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1