P3001moderate severityPowertrain
Turbo/Supercharger Boost Control Circuit Low
on 2017 Audi R8 5.2L V10 (Gen 2, 562hp) · AWD
What this code means
The signal from the turbo boost control solenoid circuit is below the expected threshold. This prevents proper boost pressure regulation.
Symptoms
- Check Engine Light
- Underboost condition
- Sluggish acceleration
- Limp mode activation
- Excessive turbo lag
Common causes
- Short to ground in boost solenoid circuit
- Faulty boost control solenoid
- Corroded wiring connector
- Failed turbo wastegate actuator
- Low system voltage
Diagnostic steps
- Measure voltage at boost control solenoid connector
- Inspect wiring for shorts to ground
- Test solenoid coil resistance
- Check wastegate actuator rod movement
- Verify battery voltage and PCM ground
Repair notes
Repair short circuit or replace boost control solenoid. Check wastegate linkage for binding.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1