P3806moderate severityPowertrain
48V Mild Hybrid Torque Assist Not Available
on 2017 Audi R8 5.2L V10 (Gen 2, 562hp) · AWD
What this code means
The 48V BSG system is unable to provide electric torque assist during acceleration events. The vehicle operates without hybrid boost.
Symptoms
- No electric assist during acceleration
- Slightly reduced off-the-line performance
- Increased fuel consumption
- Turbo lag more noticeable (if turbocharged)
- 48V system indicator may illuminate
Common causes
- 48V battery SOC too low for assist
- BSG torque output limited by temperature
- 48V system in degraded mode
- Drive belt condition preventing torque transfer
- Control software limiting assist
Diagnostic steps
- Check 48V battery SOC level
- Monitor BSG temperature
- Read 48V system inhibit reasons
- Inspect drive belt condition
- Review recent 48V system fault codes
Repair notes
Resolve underlying 48V system issue. Charge 48V battery. Replace drive belt if worn. Address thermal issues.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1