2016 HONDA S660

0.66L I3 Turbo S07ARWDAUTOMATICgasturbo
5-Year Cost of Ownership
$41,552 maintenance + known platform issues
~$8,310/yr · 690¢/mile equivalent · $36,266 maintenance + $2,686 expected platform issues
Common Problems & Known Issues

The 2016 Honda S660 is a Japan-market kei sports car with a mid-mounted turbocharged 660cc three-cylinder. While mechanically robust by Honda standards, the S07A engine's high-strung nature and CVT transmission vulnerabilities become apparent with spirited use and age.

CVT Transmission Judder and Mount Failure

Common · medium severity
Typical onset: 40,000-70,000 mi
Symptoms: Shuddering or vibration during acceleration from stop, Clunking noise when shifting from Park to Drive, Excessive engine movement visible from cabin, Delayed engagement when cold
Fix: Transmission mounts wear prematurely due to mid-engine torque loads and heat exposure. Typical fix involves replacing upper and lower transmission mounts (2.5 hours labor). If CVT itself has internal judder, fluid replacement with Honda CVTF may help temporarily, but fluid and filter service with pulleys inspected adds another 1.5 hours. Severe cases need CVT replacement.
Estimated cost: $400-800 for mounts only, $3,500-5,000 if CVT replacement required

Lifter Tick and Premature Camshaft Wear

Occasional · high severity
Typical onset: 60,000-100,000 mi
Symptoms: Cold-start ticking that persists beyond 30 seconds, Metallic rattling at idle when warm, Loss of power or rough running in severe cases, Check engine light with cam position sensor codes
Fix: S07A uses roller rocker arms and hydraulic lifters prone to collapse with oil starvation or running low-quality oil. Owners who skip 5,000-mile intervals or use incorrect viscosity see this most. Diagnosis requires valve cover removal (1 hour), but fix usually means replacing all lifters (6 total) and inspecting cam lobes for scoring—cylinder head R&R if cam worn (8-10 hours total). Some mechanics replace lifters without head removal if cam looks OK, about 5 hours labor.
Estimated cost: $1,200-1,800 lifters only, $3,000-4,500 if camshaft and head work needed

Timing Chain Stretch and Tensioner Failure

Occasional · high severity
Typical onset: 80,000-120,000 mi
Symptoms: Rattling noise from engine on cold start, Check engine light with VTC actuator or timing codes, Loss of power, rough idle, Engine won't start in extreme cases
Fix: The S07A timing chain and hydraulic tensioner can stretch or fail, especially if oil changes were neglected. Access is difficult due to mid-engine layout. Timing chain replacement requires removing engine from car in most cases (6-8 hours removal/reinstall), plus 3-4 hours for chain, guides, tensioner, and VTC actuator replacement. Total 10-12 hours labor. Always replace water pump and harmonic balancer during this job.
Estimated cost: $2,800-4,200

Transmission Oil Cooler Line Leaks

Common · medium severity
Typical onset: 50,000-90,000 mi
Symptoms: Transmission fluid spots under mid-section of car, Burnt CVT fluid smell, Low fluid level on dipstick, Slipping or hesitation under load
Fix: Rubber cooler lines and fittings degrade from engine bay heat. Located between engine and CVT near exhaust, these lines crack or weep at crimps. Replacement involves lifting car, removing underbody panels, and replacing both feed and return lines (2-3 hours). Must refill CVT with correct Honda fluid and verify no metal contamination. If neglected, CVT overheats and fails internally.
Estimated cost: $400-700

Harmonic Balancer Deterioration

Rare · medium severity
Typical onset: 70,000-110,000 mi
Symptoms: Vibration at specific RPM ranges (usually 2,500-3,500), Serpentine belt squealing or misalignment, Visible wobble of crankshaft pulley, Accessory drive noise
Fix: The rubber isolation ring in the harmonic balancer separates with age and heat cycles. Not life-threatening but causes annoying vibration and can damage crankshaft seal. Replacement requires crankshaft pulley removal with special holding tool (1.5-2 hours). Often discovered during timing chain service. Mid-engine access makes this slightly more tedious than front-engine Hondas.
Estimated cost: $350-600

Fuel Filter Clogging (JDM Fuel Quality Issue)

Occasional · low severity
Symptoms: Hesitation or stumbling under boost, Loss of top-end power, Check engine light with lean fuel trim codes, Hard starting when hot
Fix: Not necessarily a defect, but imported S660s or those run on questionable fuel see premature fuel filter restriction. The in-tank filter and inline filter should both be replaced every 30,000-40,000 miles in North America (Honda JDM spec is longer). In-tank filter requires dropping fuel tank (2.5 hours), inline filter is 0.5 hours. Many techs do both simultaneously.
Estimated cost: $300-500 for both filters
Owner tips
  • Use Honda-spec 0W-20 full synthetic and change every 5,000 miles maximum—this engine has tiny oil capacity and runs hot
  • Check CVT fluid level every 10,000 miles; mid-engine heat cooks seals and causes slow leaks
  • Inspect transmission mounts annually—they fail early and cause expensive secondary damage
  • Budget for timing chain service at 100,000 miles even if no symptoms; it's interference engine
  • If importing from Japan, verify maintenance records and expect accelerated wear on rubber components due to age
Buy one if you can verify religious oil changes and transmission mount history; otherwise budget $3,000-5,000 for deferred maintenance on any example over 60,000 miles.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
595 jobs across 17 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →