P2138critical severityPowertrain
Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation
on 2015 Jeep Wrangler 3.6L V6 · 4WD
What this code means
The dual accelerator pedal position sensors report conflicting values.
Symptoms
- Limp mode
- No throttle response
- Check engine light
- Engine at idle only
Common causes
- Failed APP sensor
- Corroded pedal connector
- Wiring fault
- 5V reference issue
Diagnostic steps
- Check APP sensor D and E voltages
- Verify 5V reference
- Inspect pedal connector
Repair notes
Replace accelerator pedal assembly. Check shared 5V reference circuit.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1