P0046moderate severityPowertrain
Turbo/Supercharger Boost Control Solenoid Circuit Range/Performance
on 2018 Jeep Wrangler 3.6L V6 · 4WD
What this code means
The boost control solenoid is not responding within expected parameters.
Symptoms
- Check Engine Light
- Overboosting or underboosting
- Reduced power
- Surging
Common causes
- Sticking solenoid
- Vacuum leak
- Wastegate stuck
- Boost pressure sensor fault
Diagnostic steps
- Monitor boost pressure vs commanded
- Test solenoid operation
- Check vacuum lines
- Inspect wastegate
Repair notes
Replace solenoid or repair wastegate.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1