P2135critical severityPowertrain
Throttle/Pedal Position Sensor/Switch A/B Voltage Correlation
on 2018 Jeep Wrangler 3.6L V6 · 4WD
What this code means
The dual throttle position sensors are reporting conflicting values, indicating a fault.
Symptoms
- Limp mode
- Reduced power
- Check engine light
- Erratic throttle response
Common causes
- Failed TPS (built into throttle body)
- Connector corrosion
- Intermittent wiring
- 5V reference circuit fault
Diagnostic steps
- Check TPS sensor A and B voltages
- Verify 5V reference
- Wiggle test wiring
- Check connector pins
Repair notes
Replace throttle body assembly (TPS is integrated). Check 5V reference shared with other sensors.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1