1995 MITSUBISHI ECLIPSE

2.4L I4FWDAUTOMATICgas
5-Year Cost of Ownership
$31,103 maintenance + known platform issues
~$6,221/yr · 520¢/mile equivalent · $5,159 maintenance + $6,994 expected platform issues
Compare this engine
vs
3.0L V6
vs
3.8L V6
Common Problems & Known Issues

The 1995 Eclipse (2G platform) is a fun, lightweight coupe with good handling, but the 2.0L turbo (4G63) suffers from crank walk and oil starvation issues, while the non-turbo 2.4L (4G64) is more reliable but underpowered. Transmission and front suspension ball joints are weak points across all trims.

Crankshaft Walk (2.0L Turbo 4G63 only)

Common · high severity
Typical onset: 60,000-120,000 mi
Symptoms: grinding noise from bellhousing area, clutch slipping or won't disengage, metal shavings in oil, engine won't start after sitting
Fix: Crankshaft thrust bearing failure allows crank to move fore-aft, destroying clutch and pilot bearing. Requires engine removal, full teardown, crank polishing or replacement, upgraded thrust bearings, and new clutch. 18-24 hours labor. Many owners opt for short block replacement or engine swap.
Estimated cost: $3,500-6,000

Automatic Transmission Failure

Common · high severity
Typical onset: 80,000-150,000 mi
Symptoms: harsh shifting between 2nd-3rd, slipping under load, delayed engagement from park, transmission overheating, metal in fluid
Fix: The F4A33 (non-turbo) and F4A51 (turbo) automatics have weak clutch packs and inadequate cooling. Oil cooler lines rust through and starve cooling. Rebuild requires 8-12 hours, but many opt for used replacement (6-8 hours). External cooler addition highly recommended.
Estimated cost: $2,200-3,800

Lower Ball Joint Failure

Common · high severity
Typical onset: 70,000-110,000 mi
Symptoms: clunking over bumps, wandering steering, uneven tire wear on inside edge, steering wheel vibration, ball joint boot torn
Fix: Front lower ball joints are pressed into control arms and fail prematurely, especially in rust-belt cars. NHTSA issued recalls but many cars still affected. Requires control arm replacement (ball joints not serviceable separately on most aftermarket arms). 2.5-3.5 hours per side.
Estimated cost: $400-700 (both sides)

Head Gasket Failure (2.4L 4G64 Non-Turbo)

Occasional · medium severity
Typical onset: 100,000-180,000 mi
Symptoms: white smoke from exhaust, bubbles in coolant reservoir, oil in coolant or vice-versa, overheating, rough idle when cold
Fix: The 2.4L non-turbo engine is generally reliable but head gaskets leak between cylinders or into coolant passages. Requires cylinder head removal, resurfacing, and new gasket set. 8-10 hours labor. Check for warped head (common if overheated).
Estimated cost: $1,200-1,800

Oil Pump and Oil Pan Leaks (2.0L Turbo)

Common · medium severity
Typical onset: 80,000-140,000 mi
Symptoms: oil dripping from front of engine, oil pressure warning light at idle when hot, ticking noise at startup, oil spots on driveway
Fix: Front case oil pump seal and oil pan gaskets leak on high-mileage 4G63 engines. Oil starvation can accelerate crank walk. Oil pan requires subframe drop (adds 2 hours). Front case seal requires timing belt removal. Combined: 6-8 hours labor.
Estimated cost: $700-1,200

Fuel Pump Failure

Occasional · high severity
Typical onset: 90,000-150,000 mi
Symptoms: no start, cranks but won't fire, engine dies at highway speed, sputtering under acceleration, whining noise from rear, long cranking before start
Fix: In-tank fuel pump dies suddenly, especially if owners run tank low repeatedly. NHTSA recall for some VINs but pumps still fail. Requires fuel tank drop. 2.5-3.5 hours labor. Replace fuel filter at same time (it's ancient by now).
Estimated cost: $500-800

Transmission Mounts Collapsing

Common · low severity
Typical onset: 60,000-100,000 mi
Symptoms: clunk when shifting into drive/reverse, excessive engine movement visible when revving, vibration through shifter, driveline shudder on hard acceleration
Fix: Rubber transmission and engine mounts deteriorate, especially on turbo models with higher torque. Front mount most common failure. Replacement straightforward: 1.5-2.5 hours for both front and rear trans mounts.
Estimated cost: $250-450
Owner tips
  • If buying a turbo model, have a pre-purchase inspection specifically check for crank walk (clutch pedal test, engine endplay measurement) — this is a deal-breaker issue
  • Change transmission fluid every 30k with Mitsubishi Diamond SP-III ATF (or equivalent Mopar ATF+4), not Dexron — wrong fluid accelerates clutch pack wear
  • Inspect ball joint boots every oil change; if torn, replace immediately before joint fails and causes loss of steering control
  • On turbo cars, use synthetic oil (10W-30 or 5W-30) and change every 3,000-4,000 miles to combat oil starvation issues in the 4G63 engine
  • Budget for timing belt replacement every 60k miles (interference engine — belt failure = valve/piston collision and $2,500+ repair)
Buy the 5-speed manual non-turbo if you want reliability; avoid turbo automatics completely; turbo manuals are fun but require deep pockets for inevitable engine work.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
469 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →