2007-2011 Dodge Nitro Cylinder Head R&R Torque Specs

3.7L V6

Applies to 2007, 2008, 2009, 2010, and 2011 Dodge Nitro

Labor Time:6 hours

Torque Values (19 specifications)

Component	Nm	lb-ft	Notes
⚠️ Camshaft Bearing Cap Bolts	14	10	Tighten in sequence, 3 passes
⚠️ Camshaft Cap Bolts	14	10	Tighten in sequence from center outward, multiple passes
⚠️ Camshaft Sprocket Bolt	80	59	Hold cam with wrench on hex
Cover Bolts	16	12	—
⚠️ Cylinder Head Bolts	65	48	TTY - tighten in sequence plus angle
⚠️ Exhaust Manifold Nuts	30	22	Apply anti-seize, work hot-to-cold
⚠️ Gasket Bolts	20	15	—
⚠️ Intake Manifold Bolts	25	18	—
Mounting Bolts	27	20	—
⚠️ Mounting Bolts	47	35	—
⚠️ Oil Drain Plug	35	26	Use new crush washer
⚠️ Rocker Arm Bolts	30	22	Tighten with cam lobe pointing away
⚠️ Rocker Arm Shaft Bolts	25	18	Tighten evenly in sequence
Sensor Bolts	11	8	—
Thermostat Housing Bolts	15	11	—
⚠️ Timing Chain Guide Bolts	12	9	Replace if worn
⚠️ Timing Chain Tensioner Bolt	25	18	Install with pin/clip to compress
⚠️ Timing Cover Bolts - 8mm	25	18	Tighten in sequence
Valve Cover Bolts	10	7	Tighten in sequence

The primary torque specification for cylinder head r&r on a 2007-2011 Dodge Nitro is 14 Nm (10 lb-ft). Note: Tighten in sequence, 3 passes

There are 19 torque specifications for cylinder head r&r on the 2007-2011 Dodge Nitro 3.7L V6, covering all related fasteners and components.