Back to 2017 Jeep Wrangler

2017 JEEP WRANGLER

3.6L V64WDAUTOMATICgas
5 active safety recalls on this vehicle — view recalls
Repairs183Labor505Torque3681Fluid9DTC922Battery0Maintenance0Recalls5
P1282high severityPowertrain

Fuel Pump Relay Control Circuit

on 2017 Jeep Wrangler 3.6L V6 · 4WD

What this code means

The PCM has detected a malfunction in the fuel pump relay control circuit. The relay is not responding correctly to PCM commands, which can prevent the fuel pump from operating or cause it to run continuously.

Symptoms

  • Check Engine Light
  • Engine cranks but will not start
  • Intermittent stalling
  • Fuel pump runs continuously with key on
  • No fuel pump prime on key-on

Common causes

  • Faulty fuel pump relay
  • Wiring open or short in relay control circuit
  • Corroded relay socket
  • PCM driver circuit failure
  • Blown fuel pump fuse

Diagnostic steps

  1. Swap fuel pump relay with known good relay of same type
  2. Check for power and ground at relay socket
  3. Test PCM relay control output
  4. Inspect relay socket for corrosion or burnt contacts
  5. Check fuel pump fuse

Repair notes

Replace the fuel pump relay and inspect the relay socket for corrosion or heat damage.

Other Powertrain codes on this vehicle

Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included.
Try ShopBase →