2013 MITSUBISHI LANCER EVOLUTION

2.0L I4 Turbo 4B11TAWDAUTOMATICgasturbo
5-Year Cost of Ownership
$63,804 maintenance + known platform issues
~$12,761/yr · 1,060¢/mile equivalent · $36,266 maintenance + $6,688 expected platform issues
Compare this engine
vs
2.0L I4 Turbo 4G63
Common Problems & Known Issues

The 2013 Evo X is a high-strung rally homologation special with a stout 4B11T engine and a transmission that's bulletproof when stock but stressed under modifications. Most issues stem from aggressive driving, deferred maintenance, or botched aftermarket tuning.

Twin-Clutch SST Transmission Pump Failure and Overheating

Common · high severity
Typical onset: 60,000-90,000 mi
Symptoms: Harsh or delayed shifts, especially when hot, Transmission entering limp mode after spirited driving, Whining noise from transmission area, Burnt transmission fluid smell
Fix: The SST twin-clutch uses a high-pressure hydraulic pump that wears out, and the factory transmission oil cooler is undersized. Pump replacement requires transmission removal (8-10 hours labor). Upgraded external cooler is mandatory to prevent repeat failure. Many shops replace clutch packs simultaneously since trans is already out.
Estimated cost: $3,500-6,000

Timing Chain Stretch and Lifter Tick (4B11T)

Occasional · high severity
Typical onset: 80,000-120,000 mi
Symptoms: Loud metallic ticking at idle that worsens when cold, Check engine light with cam/crank correlation codes (P0016, P0017), Rough idle or hesitation on cold starts, Rattling noise on startup that fades after a few seconds
Fix: The 4B11T uses a timing chain that stretches over time, particularly if oil changes were extended or low-quality oil used. Lifters can also collapse. Full timing chain kit, guides, tensioner, and lifter replacement requires 12-16 hours labor with head removal to access lifters. Must inspect cam phasers and oil control valves simultaneously.
Estimated cost: $2,800-4,500

Cracked or Worn Engine Mounts (Especially Transmission Mount)

Common · medium severity
Typical onset: 50,000-80,000 mi
Symptoms: Excessive driveline clunk during acceleration or deceleration, Vibration felt through shifter or steering wheel, Engine visibly rocking side-to-side under throttle, Difficulty engaging gears smoothly
Fix: The aggressive engine torque destroys OEM rubber mounts quickly, especially the passenger-side transmission mount. Most owners upgrade to polyurethane or solid mounts (expect more NVH). Transmission mount replacement is 2-3 hours, full set of four mounts is 4-6 hours. Alignment check recommended after.
Estimated cost: $600-1,200

Turbocharger Wastegate Rattle and Boost Creep

Occasional · medium severity
Typical onset: 70,000-110,000 mi
Symptoms: Metallic rattling from engine bay at idle or light throttle, Overboost codes or limp mode under hard acceleration, Boost gauge showing higher-than-stock pressures, Hissing or fluttering noises during spool-up
Fix: The factory IHI turbo's internal wastegate actuator rod wears and rattles, or the wastegate flapper doesn't seal properly causing uncontrolled boost. Turbo replacement or rebuild required (6-8 hours labor). Many owners upgrade to aftermarket turbos at this point. Must inspect all boost hoses and diverter valve simultaneously.
Estimated cost: $1,800-3,500

Fuel System Contamination from In-Tank Fuel Filter

Occasional · medium severity
Typical onset: null
Symptoms: Rough running or misfires under boost, Fuel trims showing overly rich or lean conditions, Loss of power at high RPM, Check engine light with fuel pressure or injector codes
Fix: The in-tank strainer/filter can collapse or become clogged, starving the high-pressure fuel pump and injectors. Requires fuel tank drop (3-4 hours labor) to replace filter and inspect pump. Often find rust or debris in tank from old fuel or poor storage. Clean injectors and replace main fuel filter while you're in there.
Estimated cost: $800-1,400

AYC (Active Yaw Control) Rear Differential Pump Failure

Rare · high severity
Typical onset: 80,000-130,000 mi
Symptoms: AYC warning light on dash, Whining or grinding noise from rear differential, Pulling to one side under acceleration, Rear diff fluid contaminated with metal shavings
Fix: The electronically-controlled rear diff uses a hydraulic pump to vary side-to-side torque split. Pump seals fail, contaminating fluid and eventually grenading the diff internals. Requires complete rear diff replacement (6-8 hours labor). Mitsubishi discontinued the AYC unit; used or aftermarket only. Some owners convert to standard mechanical diff.
Estimated cost: $3,000-5,500
Owner tips
  • Change SST transmission fluid every 15,000 miles with Mitsubishi DiaQueen fluid—not negotiable if you want the trans to survive
  • Install an aftermarket transmission oil cooler immediately, especially if you track the car or live in hot climates
  • Use 5W-30 full synthetic oil and change every 3,500-5,000 miles to prevent timing chain stretch and lifter collapse
  • Avoid tuning beyond Stage 2 without upgraded fuel system, clutches, and cooling—these engines handle 350-400whp reliably but fall apart quickly beyond that
  • Inspect and replace all rubber coolant hoses and intercooler piping around 60,000 miles—they crack and cause overboost or overheating
  • Budget $1,500-2,000/year for maintenance and expect repair surprises—this is a homologation special, not a Corolla
Buy one if you're an enthusiast who can wrench or budget $3k/year for a specialist—avoid if you want appliance-grade reliability or plan aggressive mods without supporting upgrades.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
595 jobs across 17 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →