P2200
NOx Sensor Circuit Bank 1
2000-2002 Rolls-Royce Corniche 6.75L V8 🇩🇪
High SeverityPowertrain
Description
Malfunction in the NOx sensor circuit on bank 1. Sensor may not be providing accurate readings.
Symptoms
- Check engine light
- Failed emissions
- SCR system may deactivate
Common Causes
- Failed NOx sensor
- Wiring damage
- Connector corrosion
- ECM fault
Diagnostic Steps
- Check NOx sensor connector
- Measure heater circuit
- Monitor sensor output with scan tool
Repair Notes
Replace NOx sensor bank 1. Verify wiring integrity first.
Related Codes
Other Powertrain Codes
- P0001Fuel Volume Regulator Control Circuit/Open
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0003Fuel Volume Regulator Control Circuit Low
- P0004Fuel Volume Regulator Control Circuit High
- P0010Intake Camshaft Position Actuator Circuit/Open Bank 1
- P0011Intake Camshaft Position Timing Over-Advanced Bank 1
- P0012Intake Camshaft Position Timing Over-Retarded Bank 1
- P0013Exhaust Camshaft Position Actuator Circuit/Open Bank 1
- P0014Exhaust Camshaft Position Timing Over-Advanced Bank 1
- P0015Exhaust Camshaft Position Timing Over-Retarded Bank 1
P2200 on Other Vehicles
Rolls-Royce Cullinan
2019-2024 6.75L V12 Twin Turbo
Rolls-Royce Dawn
2016-2024 6.6L V12 Twin Turbo
Rolls-Royce Ghost
2010-2024 6.6L V12 Twin Turbo
Rolls-Royce Phantom VII
2003-2017 6.75L V12
Rolls-Royce Phantom VIII
2018-2024 6.75L V12 Twin Turbo
Rolls-Royce Silver Seraph
1998-2002 5.4L V12
Rolls-Royce Silver Spirit
1990-1998 6.75L V8
Rolls-Royce Silver Spur
1990-1998 6.75L V8
Common Questions
What does code P2200 mean on a 2000-2002 Rolls-Royce Corniche?
P2200 stands for "NOx Sensor Circuit Bank 1". Malfunction in the NOx sensor circuit on bank 1. Sensor may not be providing accurate readings.
What are the symptoms of P2200 on a Rolls-Royce Corniche?
Common symptoms of P2200 include: Check engine light, Failed emissions, SCR system may deactivate.
What causes P2200 on a 2000-2002 Rolls-Royce Corniche?
Common causes of P2200 include: Failed NOx sensor, Wiring damage, Connector corrosion, ECM fault.