P0001moderate severityPowertrain
Fuel Volume Regulator Control Circuit/Open
on 2012 Toyota Sequoia 4.6L V8 · RWD
What this code means
The PCM detected an open circuit in the fuel volume regulator control circuit. This regulator controls fuel pressure in the high-pressure fuel system.
Symptoms
- Check Engine Light
- Hard starting
- Reduced power
- Poor fuel economy
Common causes
- Faulty fuel volume regulator
- Damaged wiring or connectors
- PCM failure
- Corroded terminals
Diagnostic steps
- Read freeze frame data
- Inspect wiring to fuel volume regulator
- Test regulator resistance
- Check fuel pressure
- Test PCM output
Repair notes
Replace faulty fuel volume regulator or repair wiring.
Other Powertrain codes on this vehicle
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1
P0016
Crankshaft Position/Camshaft Position Correlation Bank 1 Sensor A