The 2012 Cayman R is the lightest, most track-focused 987.2 variant with the 3.4L DFI flat-six. While the direct-injection platform fixed the IMS bearing issues of older models, these engines are prone to cylinder bore scoring and suffer from weak intermediate shaft bearings in the transmission, plus typical Porsche ancillary failures.
Cylinder Bore Scoring / Piston-to-Wall Contact
Occasional · high severityTypical onset: 40,000-80,000 mi
Symptoms: Cold-start rattle or knocking that quiets after warm-up, Excessive oil consumption (more than 1 qt per 1,000 mi), Metal fragments in oil during changes, Loss of compression in one or more cylinders
Fix: Full engine rebuild or short-block replacement required. Involves pulling the engine, machining or replacing cylinders, new pistons/rings, and reassembly. 35-45 labor hours depending on extent of damage and whether heads need work.
Estimated cost: $15,000-25,000
Transmission Intermediate Shaft Bearing Failure
Common · high severityTypical onset: 60,000-100,000 mi
Symptoms: Whining or grinding noise from transmission area, especially in lower gears, Metallic debris in transmission fluid, Sudden loss of gears or inability to shift, Transmission warning light
Fix: Transmission must be dropped and disassembled to replace the intermediate shaft and bearings. Some shops recommend full bearing upgrade kit at this point. 18-24 labor hours plus trans fluid and parts.
Estimated cost: $4,500-7,500
Direct Fuel Injector Failure
Occasional · medium severityTypical onset: 70,000-120,000 mi
Symptoms: Rough idle or misfires on cold start, Check engine light with fuel trim or misfire codes, Poor throttle response or hesitation, Fuel smell from exhaust
Fix: DFI injectors fail from carbon buildup or internal wear. Recommend replacing all six at once to avoid repeat labor. Requires removal of intake plenum. 6-8 labor hours.
Estimated cost: $2,500-4,000
Rear Main Seal and Intermediate Shaft (IMS) Seal Leaks
Common · low severityTypical onset: 50,000-90,000 mi
Symptoms: Oil pooling under car after sitting, Oil spots on driveway concentrated at rear of engine, Low oil level warnings, Visible oil on bellhousing or transmission
Fix: Engine or transmission must be dropped depending on which seal. RMS replacement typically done during clutch jobs. IMS seal (not the bearing issue of older cars, just the seal itself) can leak on DFI engines. 12-16 labor hours for RMS if done alone.
Estimated cost: $1,800-3,200
Transmission Mount Deterioration
Common · low severityTypical onset: 60,000-100,000 mi
Symptoms: Clunking during shifts or throttle transitions, Excessive drivetrain movement felt through chassis, Vibration at idle, Grinding sensation through shifter
Fix: The rubber transmission mounts fatigue from heat and track use. Replacement is straightforward but requires supporting the transmission. Often done with dogbone mount at same time. 3-5 labor hours.
Estimated cost: $800-1,400
Coolant Expansion Tank Cracking
Occasional · medium severitySymptoms: Coolant smell in cabin or from engine bay, Visible coolant drips from right side of engine bay, Low coolant warnings, Overheating in severe cases
Fix: Plastic expansion tank develops stress cracks, usually at mounting tabs or seams. Simple replacement but requires coolant system purge. 2-3 labor hours.
Estimated cost: $400-700
Water Pump Failure (Electric Auxiliary Pump)
Occasional · medium severityTypical onset: 80,000-120,000 mi
Symptoms: Overheating at idle or in traffic, Coolant temperature spikes after shutting off engine, Warning messages about coolant system, Whining noise from right side of engine bay
Fix: The auxiliary electric water pump fails and stops circulating coolant after engine shutoff, leading to heat soak issues. Replacement requires access from wheel well. 3-4 labor hours.
Estimated cost: $800-1,300
Buy one if you can afford the potential engine rebuild and have an independent Porsche specialist lined up—when they're healthy, they're incredible, but the bore scoring risk is real and expensive.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.