Transmission Output Shaft Bearing Noise Detected
2014-2014 Audi A6 3.0L Supercharged V6
The 2014 Audi A6 is equipped with a 3.0L V6 engine. Below you'll find detailed p3067 diagnostic code information including labor time estimates, cost ranges, and technician notes specific to this engine configuration.
Description
The TCM or vibration sensor has detected a signature consistent with output shaft bearing wear in the transmission.
Symptoms
- Whining noise proportional to vehicle speed
- Noise changes with load but not with gear
- Vibration felt through floor
- Noise present in all gears
- Transmission fluid may have metallic sheen
Common Causes
- Output shaft bearing wear
- Insufficient lubrication
- Bearing preload incorrect
- High mileage wear
- Contaminated fluid causing bearing damage
Diagnostic Steps
- Listen for bearing noise at varying speeds
- Check transmission fluid for metal particles
- Perform vibration analysis
- Road test in multiple gears to isolate source
- Inspect transmission for external leaks
Repair Notes
Transmission removal and bearing replacement required. Inspect output shaft for scoring. Replace fluid and filter.
Related Codes
Other Powertrain Codes
- P0001Fuel Volume Regulator Control Circuit/Open
- P0001Fuel Volume Regulator Control Circuit/Open
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0003Fuel Volume Regulator Control Circuit Low
- P0003Fuel Volume Regulator Control Circuit Low
- P0004Fuel Volume Regulator Control Circuit High
- P0004Fuel Volume Regulator Control Circuit High
- P0010Intake Camshaft Position Actuator Circuit/Open Bank 1
- P0010Intake Camshaft Position Actuator Circuit/Open Bank 1
P3067 on Other Vehicles
Common Questions
What does code P3067 mean on a 2014-2014 Audi A6?
P3067 stands for "Transmission Output Shaft Bearing Noise Detected". The TCM or vibration sensor has detected a signature consistent with output shaft bearing wear in the transmission.
What are the symptoms of P3067 on a Audi A6?
Common symptoms of P3067 include: Whining noise proportional to vehicle speed, Noise changes with load but not with gear, Vibration felt through floor, Noise present in all gears, Transmission fluid may have metallic sheen.
What causes P3067 on a 2014-2014 Audi A6?
Common causes of P3067 include: Output shaft bearing wear, Insufficient lubrication, Bearing preload incorrect, High mileage wear, Contaminated fluid causing bearing damage.
Last updated: March 2026