P1370moderate severityPowertrain
IC Module 4X Reference Circuit Too Many Pulses
on 2014 Cadillac ATS 2.5L I4 · RWD
What this code means
The PCM detected too many pulses from the 4X reference signal in the ignition control circuit. This can be caused by electrical noise or a failing component.
Symptoms
- Check Engine Light
- Engine misfires
- Timing issues
- Rough running
Common causes
- Damaged crankshaft reluctor wheel (extra material)
- Electrical noise in 4X circuit
- Faulty ignition control module
- Wiring interference
Diagnostic steps
- Scope 4X reference signal for extra pulses
- Inspect crankshaft reluctor wheel
- Check wiring for electromagnetic interference
- Test IC module
Repair notes
Inspect reluctor wheel for damage. Shield wiring from interference sources. Replace IC module if faulty.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1