Brake Pedal Position Sensor Circuit
2008-2008 Chevrolet Impala 3.5L V6
The 2008 Chevrolet Impala is equipped with a 3.5L V6 engine. Below you'll find detailed c0100 diagnostic code information including labor time estimates, cost ranges, and technician notes specific to this engine configuration.
Description
General malfunction in the brake pedal position sensor, which provides analog brake apply data to the ABS/stability module.
Symptoms
- ABS warning light
- Stability control disabled
- Regenerative braking fault on hybrids
- Brake assist may not activate
Common Causes
- Faulty brake pedal position sensor
- Sensor wiring damage
- Connector corrosion at sensor
- ABS module input failure
Diagnostic Steps
- Read brake pedal position with scan tool while pressing pedal
- Check for smooth, proportional signal
- Inspect sensor wiring and connector
- Test sensor supply voltage
- Check for related brake switch codes
Repair Notes
Replace brake pedal position sensor. Verify smooth signal across full pedal travel.
Related Codes
Other Chassis Codes
- C0021LF Wheel Speed Sensor Range/Performance
- C0022RF Wheel Speed Sensor Range/Performance
- C0023LR Wheel Speed Sensor Range/Performance
- C0024RR Wheel Speed Sensor Range/Performance
- C0025LF Wheel Speed Sensor Circuit Intermittent
- C0026RF Wheel Speed Sensor Circuit Intermittent
- C0027LR Wheel Speed Sensor Circuit Intermittent
- C0028RR Wheel Speed Sensor Circuit Intermittent
- C0035Left Front Wheel Speed Sensor Circuit
- C0036Left Front Wheel Speed Signal Erratic
C0100 on Other Vehicles
Chevrolet Astro
1996-1996 4.3L V6 Vortec
Chevrolet Astro
1997-1997 4.3L V6 Vortec
Chevrolet Astro
1998-1998 4.3L V6 Vortec
Chevrolet Astro
1999-1999 4.3L V6 Vortec
Chevrolet Astro
2000-2000 4.3L V6 Vortec
Chevrolet Astro
2001-2001 4.3L V6 Vortec
Chevrolet Astro
2002-2002 4.3L V6 Vortec
Chevrolet Astro
2003-2003 4.3L V6 Vortec
Common Questions
What does code C0100 mean on a 2008-2008 Chevrolet Impala?
C0100 stands for "Brake Pedal Position Sensor Circuit". General malfunction in the brake pedal position sensor, which provides analog brake apply data to the ABS/stability module.
What are the symptoms of C0100 on a Chevrolet Impala?
Common symptoms of C0100 include: ABS warning light, Stability control disabled, Regenerative braking fault on hybrids, Brake assist may not activate.
What causes C0100 on a 2008-2008 Chevrolet Impala?
Common causes of C0100 include: Faulty brake pedal position sensor, Sensor wiring damage, Connector corrosion at sensor, ABS module input failure.
Last updated: March 2026
View Labor Times | View Torque Specs | View Fluid Specs | View Battery Specs