P1811high severityPowertrain
Maximum Adapt and Long Shift
on 2008 Chevrolet Impala 3.5L V6 · FWD
What this code means
The TCM has raised hydraulic line pressure to maximum to compensate for excessively worn clutch packs or other internal components. The TCM detected shift times exceeding 0.65 seconds too many times. This is a serious transmission code indicating internal wear. Common on GM front-wheel-drive vehicles with the 4T65E transmission.
Symptoms
- Extremely harsh 1-2 and 2-3 shifts (feels like being rear-ended)
- Check Engine Light
- Hard shifting in all gears
- Shuddering between shifts
- Whining noise from transmission
- Transmission slipping before hard shift
Common causes
- Worn clutch packs (most common)
- Faulty pressure control solenoid
- Low transmission fluid
- Blocked valve body
- Worn seals causing pressure loss
- Contaminated transmission fluid
Diagnostic steps
- Check transmission fluid level and condition
- Test line pressure
- Monitor shift times with scan tool
- Test pressure control solenoid
- Inspect valve body for wear
- Check for related solenoid codes
Repair notes
Change transmission fluid and filter first. If code returns, test pressure control solenoid. In many cases, a transmission rebuild is needed due to worn clutches. A TransGo shift kit can extend life by shortening shift times. Common on Impala, Monte Carlo, Grand Prix, Regal, Century, and Venture.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1