Camshaft Profile Actuator A Stuck Bank 1
2012-2019 Fiat 500 1.4L I4
Description
The camshaft profile switching actuator for Bank 1, intake side, is mechanically stuck in one position. Multi-profile camshafts switch between low and high RPM cam lobes.
Symptoms
- Check Engine Light
- Loss of high-RPM power
- Rough idle if stuck on high cam
- VTEC/VANOS-like system not engaging
- Engine sounds different at high RPM
Common Causes
- Oil sludge blocking actuator passages
- Actuator solenoid failure
- Low oil pressure
- Worn actuator pins or springs
- Incorrect oil viscosity
Diagnostic Steps
- Check engine oil level and condition
- Monitor camshaft profile PID on scan tool
- Command profile switch and verify response
- Test oil pressure at actuator feed
- Inspect actuator screen for debris
Repair Notes
Flush engine oil system. Replace cam profile actuator solenoid. If pins are worn, camshaft replacement may be needed.
Related Codes
Other Powertrain Codes
- P0001Fuel Volume Regulator Control Circuit/Open
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0003Fuel Volume Regulator Control Circuit Low
- P0004Fuel Volume Regulator Control Circuit High
- P0010Intake Camshaft Position Actuator Circuit/Open Bank 1
- P0011Intake Camshaft Position Timing Over-Advanced Bank 1
- P0012Intake Camshaft Position Timing Over-Retarded Bank 1
- P0013Exhaust Camshaft Position Actuator Circuit/Open Bank 1
- P0014Exhaust Camshaft Position Timing Over-Advanced Bank 1
- P0015Exhaust Camshaft Position Timing Over-Retarded Bank 1
P3010 on Other Vehicles
Fiat 124 Spider
2017-2020 1.4L I4 Turbo
Fiat 500 Abarth
2012-2019 1.4L I4 Turbo
Fiat 500 BR
2011-2020 1.4L I4 Flex Fire Evo
Fiat 500 PL
2007-2025 1.0L I3 Hybrid FireFly 70
Fiat 500 PL
2007-2025 1.2L I4 Fire 69
Fiat 500L
2014-2020 1.4L I4 Turbo
Fiat 500X
2016-2024 1.4L I4 Turbo
Fiat Argo
2017-2025 1.0L I4 Flex Firefly
Common Questions
What does code P3010 mean on a 2012-2019 Fiat 500?
P3010 stands for "Camshaft Profile Actuator A Stuck Bank 1". The camshaft profile switching actuator for Bank 1, intake side, is mechanically stuck in one position. Multi-profile camshafts switch between low and high RPM cam lobes.
What are the symptoms of P3010 on a Fiat 500?
Common symptoms of P3010 include: Check Engine Light, Loss of high-RPM power, Rough idle if stuck on high cam, VTEC/VANOS-like system not engaging, Engine sounds different at high RPM.
What causes P3010 on a 2012-2019 Fiat 500?
Common causes of P3010 include: Oil sludge blocking actuator passages, Actuator solenoid failure, Low oil pressure, Worn actuator pins or springs, Incorrect oil viscosity.