1999 HONDA INTEGRA TYPE R DC2

1.8L I4 VTEC B18CFWDAUTOMATICgas
5-Year Cost of Ownership
$38,126 maintenance + known platform issues
~$7,625/yr · 640¢/mile equivalent · $32,383 maintenance + $5,043 expected platform issues
Common Problems & Known Issues

The DC2 Integra Type R is a highly-strung naturally-aspirated performance machine with Honda's legendary B18C5 engine. Most issues stem from age, hard use, and deferred maintenance rather than design flaws—these cars are now 25+ years old and many have been driven enthusiastically or modified poorly.

Valve Clearance Out of Spec / Worn Camshaft Lobes

Common · medium severity
Typical onset: 100,000-150,000 mi
Symptoms: Valve train noise on cold start, Loss of power especially in VTEC crossover, Rough idle, Check engine light with misfire codes
Fix: Valve adjustment requires 2-3 hours labor. If cam lobes are worn, cylinder head removal and camshaft replacement needed—8-12 hours labor. Often find worn rocker arms and require all lifters/tappets replaced at same time. Head resurfacing may be necessary if overheated previously.
Estimated cost: $400-800 for adjustment only, $2,500-4,000 for cam replacement with head work

Synchro Wear in 2nd and 3rd Gear

Common · medium severity
Typical onset: 80,000-120,000 mi
Symptoms: Grinding or crunching on 2-3 shift under spirited driving, Difficulty engaging 2nd gear when cold, Notchy shifting, Complete lockout of 2nd gear in worst cases
Fix: The cable-shifted S80 transmission is robust but synchros wear from aggressive shifting and clutch dump launches. Full transmission rebuild requires 10-14 hours labor including removal. Common to replace all synchros, bearings, and seals while in there. Many shops won't attempt synchro-only jobs—it's rebuild or replace.
Estimated cost: $2,800-4,500 for rebuild, $1,500-2,500 for used JDM transmission swap

Deteriorated Transmission Mounts

Common · low severity
Typical onset: 60,000-100,000 mi
Symptoms: Excessive shifter vibration at idle, Clunking on acceleration/deceleration, Harsh engagement into gear, Visible sagging of transmission when inspected on lift
Fix: All three motor mounts and the rear transmission mount deteriorate badly, especially if tracked or launched hard. Rear trans mount is most critical—2 hours labor. Doing all four mounts at once takes 3-4 hours. OEM Honda mounts last longer than aftermarket polyurethane which transmit more NVH.
Estimated cost: $400-700 for all mounts with labor

Leaking Valve Cover Gasket and Spark Plug Tube Seals

Common · low severity
Typical onset: 80,000+ mi
Symptoms: Oil weeping down side of engine, Burning oil smell especially after spirited driving, Oil pooling in spark plug wells causing misfires, Smoke from engine bay at stops
Fix: Classic Honda B-series issue. Valve cover gasket and spark plug tube seals harden with age and heat cycles. Job takes 2-3 hours including proper cleaning of mating surfaces. Must use genuine Honda gasket—aftermarket versions leak within 6 months. Good time to inspect cam lobes and adjust valves while cover is off.
Estimated cost: $300-500

Cracked or Failing Harmonic Balancer

Occasional · high severity
Typical onset: 120,000+ mi
Symptoms: Visible wobble of crankshaft pulley at idle, Rubber ring separation from hub, Serpentine belt walking off pulleys, Rough vibration through entire car, Sudden loss of power steering and alternator
Fix: The original rubber isolator deteriorates and the outer ring can separate or wobble. If it fails completely, accessory belts shred and engine timing can be affected. Replacement requires 3-4 hours labor—must remove front motor mount and use special holding tool to remove crank bolt (torque spec is critical on reassembly). Inspect closely on any pre-purchase inspection.
Estimated cost: $500-800

Overheating from Neglected Cooling System

Occasional · high severity
Symptoms: Temperature gauge climbing past normal especially in traffic, Coolant leaks from radiator end tanks, Steam from hood, Heater blowing cold at idle, Warped head or blown head gasket if severely overheated
Fix: Original radiators often have plastic end tank failure. Water pumps last 80,000-100,000 mi. Thermostat sticking closed is common. If overheated severely, head gasket replacement requires 8-10 hours labor and head must be checked for warpage and resurfaced. Many B18C5 engines have been ruined by ignoring overheating—aluminum head warps easily.
Estimated cost: $400-800 for cooling system refresh, $1,800-3,000 for head gasket with resurface

Chassis and Subframe Rust (JDM and UK Models)

Occasional · high severity
Symptoms: Visible rust perforation on rear subframe mounting points, Rust around rear shock towers, Deterioration of floor pans especially driver side, Cracking paint on underside revealing surface rust
Fix: JDM-imported DC2s and UK-market cars often have significant rust from damp climates and poor rustproofing. Rear subframe mounting points are structural and unsafe when compromised—professional welding and plating required, 12-20 hours labor for proper repair. Some cars are economically totaled by this issue. USDM cars less affected but still check thoroughly.
Estimated cost: $2,000-5,000+ depending on severity, some not economically repairable
Owner tips
  • Change transmission fluid every 30,000 mi with genuine Honda MTF—cheaper fluids destroy synchros faster
  • Adjust valve clearances every 30,000 mi religiously—this prevents cam lobe wear and maintains VTEC performance
  • Replace timing belt and water pump every 60,000 mi regardless of age—interference engine will bend valves if belt breaks
  • Use quality 5W-30 or 10W-30 oil and change every 3,000-5,000 mi—high-revving VTEC engines are hard on oil
  • Inspect harmonic balancer and all motor mounts at every service—catching them early prevents expensive secondary damage
  • For JDM imports, get a thorough underside inspection for rust before purchase—surface rust is fine, structural perforation is a deal-breaker
Absolutely buy one if maintenance history is documented and rust-free, but budget $2,000-3,000 immediately for deferred maintenance on any 25-year-old example—these are now collector cars that reward proper care.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
591 jobs across 17 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →