P3025moderate severityPowertrain
CVT Fluid Temperature Sensor Circuit
on 2014 Jeep Wrangler 3.6L V6 · 4WD
What this code means
The CVT fluid temperature sensor is reporting values outside the expected range.
Symptoms
- Check Engine Light
- Incorrect temperature display
- Fan may run continuously
- Transmission may overheat
- Delayed protection mode activation
Common causes
- Faulty temperature sensor
- Corroded sensor connector
- Damaged wiring
- Sensor out of calibration
- Short in circuit
Diagnostic steps
- Read CVT fluid temp PID
- Compare to actual temp with infrared thermometer
- Test sensor resistance vs temperature
- Inspect connector and wiring
- Check for shorts to ground or power
Repair notes
Replace CVT fluid temperature sensor.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1