P1288moderate severityPowertrain
Intake Manifold Short Runner Solenoid Circuit
on 2017 Jeep Wrangler 3.6L V6 · 4WD
What this code means
The PCM has detected a malfunction in the intake manifold short runner solenoid valve circuit. This solenoid controls the short runner valve position to optimize airflow at different engine speeds for improved torque and efficiency.
Symptoms
- Check Engine Light
- Reduced mid-range torque
- Slight hesitation on acceleration
- Minor fuel economy decrease
Common causes
- Faulty short runner solenoid valve
- Wiring open or short to solenoid
- Corroded solenoid connector
- Carbon buildup on runner valve preventing movement
- Vacuum leak at solenoid actuator
Diagnostic steps
- Test solenoid resistance with multimeter
- Command solenoid on and off with scan tool and listen for click
- Inspect solenoid wiring and connector
- Check vacuum supply to runner valve actuator
- Inspect runner valve for carbon buildup or binding
Repair notes
Replace the short runner solenoid valve if electrically faulty; clean carbon from runner valve if mechanically stuck.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1