P1611low severityPowertrain
MIL Request Signal Circuit Voltage Low
on 2015 Kia Forte 1.8L I4 · FWD
What this code means
The PCM has detected a low voltage condition on the MIL (Malfunction Indicator Lamp) request signal circuit. The circuit that controls the Check Engine Light on the instrument cluster is not functioning at the correct voltage.
Symptoms
- Check Engine Light may not illuminate when it should
- Possible false MIL illumination
- Instrument cluster communication issue
Common causes
- Short to ground in MIL control circuit
- Faulty instrument cluster
- Wiring issue between PCM and instrument cluster
- PCM MIL driver failure
- Corroded connector
Diagnostic steps
- Check MIL operation with scan tool MIL command
- Inspect wiring between PCM and instrument cluster
- Test MIL circuit for shorts to ground
- Check instrument cluster connector
- Verify PCM MIL output
Repair notes
Repair the wiring in the MIL control circuit or replace the instrument cluster if it is at fault.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1