C0080
Steering Position Sensor Calibration Not Performed
2016-2021 Mazda CX-3 2.0L I4
Low SeverityChassisGeneric (SAE)
Description
The steering angle sensor has not been calibrated or the calibration was lost.
Symptoms
- Stability control light on
- ESC inoperative
- Lane departure warning inactive
- Steering center point unknown to module
Common Causes
- Battery disconnect cleared calibration
- Alignment performed without recalibration
- Module replacement
- Steering component service
Diagnostic Steps
- Perform steering angle sensor calibration with scan tool
- Drive vehicle in a circle to auto-learn center point
- Verify calibration completed successfully
- Check for other stability codes that prevent calibration
Repair Notes
Perform steering angle sensor calibration. Most vehicles require a scan tool procedure followed by a driving routine.
Related Codes
Other Chassis Codes
- C0021LF Wheel Speed Sensor Range/Performance
- C0021LF Wheel Speed Sensor Range/Performance
- C0022RF Wheel Speed Sensor Range/Performance
- C0022RF Wheel Speed Sensor Range/Performance
- C0023LR Wheel Speed Sensor Range/Performance
- C0023LR Wheel Speed Sensor Range/Performance
- C0024RR Wheel Speed Sensor Range/Performance
- C0024RR Wheel Speed Sensor Range/Performance
- C0025LF Wheel Speed Sensor Circuit Intermittent
- C0025LF Wheel Speed Sensor Circuit Intermittent
C0080 on Other Vehicles
Common Questions
What does code C0080 mean on a 2016-2021 Mazda CX-3?
C0080 stands for "Steering Position Sensor Calibration Not Performed". The steering angle sensor has not been calibrated or the calibration was lost.
What are the symptoms of C0080 on a Mazda CX-3?
Common symptoms of C0080 include: Stability control light on, ESC inoperative, Lane departure warning inactive, Steering center point unknown to module.
What causes C0080 on a 2016-2021 Mazda CX-3?
Common causes of C0080 include: Battery disconnect cleared calibration, Alignment performed without recalibration, Module replacement, Steering component service.