2013 MERCEDES-BENZ S600

5.5L V12 BiTurbo M275RWDAUTOMATICgasturbo
5-Year Cost of Ownership
$134,123 maintenance + known platform issues
~$26,825/yr · 2,240¢/mile equivalent · $55,587 maintenance + $51,186 expected platform issues
Compare this engine
vs
6.0L V12 BiTurbo M279
vs
5.8L V12
Common Problems & Known Issues

The 2013 S600 with the M275 5.5L twin-turbo V12 is a complex flagship sedan with catastrophic engine reliability issues centered around defective cylinder wall coatings and bearing failures. When maintained meticulously these cars are impressive, but the engine is a ticking time bomb that can grenade without warning.

Catastrophic Engine Failure - Nikasil Coating & Bore Scoring

Common · high severity
Typical onset: 40,000-80,000 mi
Symptoms: Metallic rattling on cold start that disappears when warm, Excessive oil consumption (1 quart per 500-1000 miles), White or blue smoke from exhaust on startup, Loss of compression in one or more cylinders, Complete engine seizure in worst cases
Fix: The M275 suffers from defective Nikasil cylinder wall coating that wears prematurely, leading to piston slap, scoring, and eventually complete failure. Requires full engine rebuild with re-sleeved cylinders or short block replacement. 60-80 hours labor for rebuild, 40-50 hours for short block swap. Many shops won't touch it—you're looking at specialist territory.
Estimated cost: $25,000-45,000

Rod Bearing and Main Bearing Failure

Common · high severity
Typical onset: 60,000-100,000 mi
Symptoms: Deep knocking sound from lower engine that increases with RPM, Sudden drop in oil pressure, Metal shavings in oil during changes, Check engine light with low oil pressure codes, Engine can fail completely within minutes of first symptoms
Fix: The M275 has inadequate bearing clearances and oil delivery issues that cause premature bearing wear. Once knocking starts, it's already too late—metal debris contaminates the entire system. Requires full engine teardown, crankshaft inspection/machining, all new bearings, and often new pistons and rods. 70-90 hours labor. Preventive bearing replacement at 60k miles is cheaper than the alternative.
Estimated cost: $18,000-35,000

Turbocharger Failure and Oil Line Leaks

Occasional · high severity
Typical onset: 80,000-120,000 mi
Symptoms: High-pitched whining or whistling under acceleration, Sudden loss of power and boost, Blue smoke from exhaust under load, Oil pooling under car near firewall area, P0299 underboost codes or P0234 overboost codes
Fix: Twin turbos fail from oil starvation (related to bearing debris from engine issues) or worn seals. Oil feed and return lines become brittle and leak. Each turbo requires 8-12 hours labor to replace due to V12 packaging. Oil lines add another 4-6 hours. Must address root cause of oil contamination or new turbos will fail quickly.
Estimated cost: $8,000-15,000

Transmission Oil Cooler Failure and Transmission Mount Collapse

Common · medium severity
Typical onset: 70,000-110,000 mi
Symptoms: Transmission fluid leaking near radiator area, Harsh shifting or delayed engagement, Clunking when shifting from Park to Drive, Visible engine/trans movement during acceleration, Pink or red fluid mixing with coolant in overflow tank
Fix: The external oil cooler develops leaks at crimped connections, causing fluid loss and potential trans damage. Hydraulic transmission mount fails from the massive V12 torque. Cooler replacement is 3-4 hours, mount is 5-7 hours due to subframe work required. Replace both together since you're in there anyway.
Estimated cost: $2,800-4,500

ABC Suspension Pump and Accumulator Failure

Occasional · medium severity
Typical onset: 80,000-130,000 mi
Symptoms: Car sits noticeably lower on one corner or all corners, ABC warning light with 'Stop vehicle too low' message, Loud humming or whining from under hood, Harsh ride quality and no self-leveling, Hydraulic fluid leaks under vehicle
Fix: Active Body Control system uses high-pressure hydraulic pump and accumulators that wear out. Pump rebuild is 6-8 hours, accumulator replacement 2-3 hours each (there are multiple). Front struts commonly leak as well. ABC specialist strongly recommended—incorrect work can damage $3k+ struts.
Estimated cost: $4,000-8,000

Fuel System Issues - High Pressure Pump and Injector Failures

Occasional · medium severity
Typical onset: 90,000-140,000 mi
Symptoms: Extended cranking before engine starts, Rough idle and misfires when cold, Loss of power at higher RPMs, P0087 fuel rail pressure too low codes, Strong fuel smell from engine bay
Fix: High-pressure fuel pump fails due to contamination or wear, and the 12 direct injectors can clog or leak. Pump replacement is 4-6 hours. Injectors are 2-3 hours each due to V12 access issues—replacing all 12 is 20-25 hours. Fuel filter (often neglected) should be changed every 20k miles but many owners skip it, accelerating pump death.
Estimated cost: $3,500-12,000
Owner tips
  • Change oil every 5,000 miles maximum with OEM Mercedes 0W-40 spec oil—extended intervals will kill the bearings
  • Have oil analysis done every change to monitor bearing wear metals (iron, copper, aluminum)—it's your only early warning
  • Replace fuel filter every 20,000 miles religiously—it's cheap insurance for the $2,500 high-pressure pump
  • Budget $3,000-5,000 annually for maintenance even if nothing breaks—this is not a Lexus
  • Find a Mercedes V12 specialist before you need one—general shops will refuse this engine or quote astronomical prices
  • Consider an extended warranty that specifically covers internal engine components if buying used—read the fine print carefully
Absolutely not unless you have a $30k emergency fund earmarked for engine replacement and understand you're buying automotive art, not transportation—the M275 V12 is legendarily unreliable and will bankrupt most owners.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
597 jobs across 18 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →