U2064moderate severityNetwork
Module Not Configured
on 2008 Subaru Legacy 3.0L H6 · AWD
What this code means
A control module has been installed but not configured or initialized for operation in this vehicle.
Symptoms
- Module features not working
- System reports module not present
- Cannot access module settings
- Module in manufacturing mode
Common causes
- New module not initialized
- Configuration procedure not performed
- Module programming incomplete
- End-of-line setup not done
Diagnostic steps
- Perform module initialization procedure
- Run post-installation configuration
- Program module with vehicle data
- Complete setup routine
- Verify module exits manufacturing mode
Repair notes
Complete the module initialization and configuration procedure using the manufacturer tool.
Other Network codes on this vehicle
U0001
High Speed CAN Communication Bus
U0002
High Speed CAN Communication Bus Performance
U0003
High Speed CAN Communication Bus (+) Open
U0004
High Speed CAN Communication Bus (+) Low
U0005
High Speed CAN Communication Bus (+) High
U0006
High Speed CAN Communication Bus (-) Open
U0007
High Speed CAN Communication Bus (-) Low
U0008
High Speed CAN Communication Bus (-) High
U0009
High Speed CAN Communication Bus Shorted Together
U0010
Medium Speed CAN Communication Bus