B1010low severityBody
TPMS Receiver Module Malfunction
on 2010 Toyota 4Runner 4.0L V6 · 4WD
What this code means
Malfunction in the TPMS receiver module that receives RF signals from tire pressure sensors.
Symptoms
- TPMS warning light flashing then solid
- No tire pressures displayed for any wheel
- TPMS system completely inoperative
Common causes
- Faulty TPMS receiver module
- Receiver antenna disconnected
- Wiring issue
- Module power supply fault
- Aftermarket tint or coating blocking RF signal
Diagnostic steps
- Check TPMS module power and ground
- Test receiver antenna connection
- Scan TPMS module for codes
- Check for aftermarket window tint with metallic content
- Verify module communication on CAN bus
Repair notes
Replace TPMS receiver module or repair antenna connection. Metallic window tint can block sensor RF signals.
Other Body codes on this vehicle
B0001
Driver Frontal Stage 1 Deployment Control
B0002
Driver Frontal Stage 2 Deployment Control
B0003
Passenger Frontal Stage 1 Deployment Control
B0004
Passenger Frontal Stage 2 Deployment Control
B0005
Driver Knee Airbag Deployment Circuit
B0006
Passenger Knee Airbag Deployment Circuit
B0007
Rear Left Side Airbag Deployment Circuit
B0008
Rear Right Side Airbag Deployment Circuit
B0010
Driver Side Airbag Deployment
B0011
Driver Side Airbag Deployment Circuit Open