P1500moderate severityPowertrain
Starter Signal Circuit
on 2008 Toyota Highlander 3.5L V6 · AWD
What this code means
The ECM is not receiving the proper signal from the starter motor circuit.
Symptoms
- CEL
- Extended cranking
- Rough startup
- Poor cold start
Common causes
- Faulty starter relay
- Damaged wiring
- Poor ground
- Faulty ignition switch
Diagnostic steps
- Test starter signal wire
- Check relay operation
- Inspect wiring
- Test ignition switch
Repair notes
Repair starter signal circuit.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1