C0325low severityChassis
Ride Height Sensor Calibration Required
on 2010 Toyota Highlander 2.7L I4 · FWD
What this code means
One or more ride height sensors require calibration after service or replacement.
Symptoms
- Suspension warning light
- Incorrect ride height all corners
- Vehicle rides too high or too low
- Ride height asymmetric
Common causes
- Sensor replaced without calibration
- Suspension component service
- Module replacement
- Battery disconnect on some vehicles
Diagnostic steps
- Perform ride height sensor calibration with scan tool
- Verify vehicle is on level ground with correct tire pressure
- Check that all sensors are reading plausible values
- Confirm calibration procedure completed successfully
Repair notes
Perform ride height calibration on level surface with correct tire pressures and no load.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0026
RF Wheel Speed Sensor Circuit Intermittent
C0027
LR Wheel Speed Sensor Circuit Intermittent
C0028
RR Wheel Speed Sensor Circuit Intermittent
C0035
Left Front Wheel Speed Sensor Circuit
C0036
Left Front Wheel Speed Signal Erratic