C0080low severityChassis
Steering Position Sensor Calibration Not Performed
on 2008 Kia Optima 2.4L I4 · FWD
What this code means
The steering angle sensor has not been calibrated or the calibration was lost.
Symptoms
- Stability control light on
- ESC inoperative
- Lane departure warning inactive
- Steering center point unknown to module
Common causes
- Battery disconnect cleared calibration
- Alignment performed without recalibration
- Module replacement
- Steering component service
Diagnostic steps
- Perform steering angle sensor calibration with scan tool
- Drive vehicle in a circle to auto-learn center point
- Verify calibration completed successfully
- Check for other stability codes that prevent calibration
Repair notes
Perform steering angle sensor calibration. Most vehicles require a scan tool procedure followed by a driving routine.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0026
RF Wheel Speed Sensor Circuit Intermittent
C0027
LR Wheel Speed Sensor Circuit Intermittent
C0028
RR Wheel Speed Sensor Circuit Intermittent
C0035
Left Front Wheel Speed Sensor Circuit
C0036
Left Front Wheel Speed Signal Erratic