2011 TOYOTA HIGHLANDER

2.7L I4FWDAUTOMATICgas
5-Year Cost of Ownership
$11,530 maintenance + known platform issues
~$2,306/yr · 190¢/mile equivalent · $5,470 maintenance + $5,360 expected platform issues
Compare this engine
vs
2.5L I4 Hybrid
vs
3.5L V6
Common Problems & Known Issues

The 2011 Highlander is generally solid, but the 2.7L I4 has catastrophic oil consumption issues, and all models share some transmission cooler and water pump vulnerabilities. The 3.5L V6 and Hybrid are far more reliable choices.

2.7L I4 Excessive Oil Consumption / Engine Failure

Common · high severity
Typical onset: 60,000-120,000 mi
Symptoms: Burning 1+ quart per 1,000 miles, Blue smoke on startup or acceleration, Low oil warning light, Engine knock or misfire, Complete engine seizure if oil runs dry
Fix: Piston ring design allows oil to bypass into combustion chamber. Toyota had a ZE2 program for some VINs but many weren't covered. Real fix is engine rebuild (rings, pistons, hone cylinders) at 25-35 hours, or short block replacement at 20-28 hours. Many owners just add oil constantly until trade-in.
Estimated cost: $4,500-7,500

Transmission Oil Cooler Line Corrosion / Leaks

Common · medium severity
Typical onset: 80,000-150,000 mi
Symptoms: ATF puddle under vehicle, driver-side front, Transmission running hotter than normal, Pink fluid dripping near radiator, Burnt transmission smell if fluid gets low
Fix: Steel cooler lines rust through where they pass near frame rail or bolt to radiator, especially in salt states. Replace both lines as a pair (one fails, other follows soon). 2-3 hours labor, lines run about $150-250 for OE Toyota parts. Flush transmission fluid after repair.
Estimated cost: $400-650

Water Pump Failure (3.5L V6)

Occasional · high severity
Typical onset: 100,000-140,000 mi
Symptoms: Coolant leak from front of engine, Squealing or grinding noise from accessory drive, Overheating, Coolant in oil (bearing seal failure)
Fix: Water pump is externally driven but seal failure can contaminate oil. Not a timing chain service item, but still 4-5 hours labor due to access (remove belts, alternator, sometimes AC compressor). Always do thermostat and serpentine belt at same time. If coolant mixed with oil, engine may need flushing or teardown.
Estimated cost: $650-1,100

Transmission Mount Collapse

Occasional · low severity
Typical onset: 90,000-150,000 mi
Symptoms: Clunk when shifting from Park to Drive or Reverse, Vibration at idle in gear, Transmission sag visible on inspection
Fix: Rear transmission mount (torque strut) rubber deteriorates and allows excessive movement. Simple replacement, 1-1.5 hours labor. OE Toyota mount preferred; aftermarket often fails quickly. Inspect engine mounts at same time—if those are also collapsed, do all three.
Estimated cost: $200-350

Front Lower Control Arm Bushing Deterioration

Occasional · medium severity
Typical onset: 80,000-130,000 mi
Symptoms: Clunking over bumps, Steering wander or vague feel, Inner tire edge wear, Alignment won't hold specs
Fix: Rear bushings in front lower control arms crack and allow camber/caster shift. Most shops replace entire control arm rather than press bushings (2-2.5 hours per side). Always do alignment after. If ball joints are also worn, do those at the same time to save labor overlap.
Estimated cost: $500-800 both sides

Hybrid Inverter Coolant Pump Failure (Hybrid only)

Occasional · high severity
Typical onset: 120,000-180,000 mi
Symptoms: Red triangle warning light, P0A93 or P0A94 codes (inverter cooling system), Hybrid system shuts down, runs on gas only, Buzzing or whining from under rear seat area
Fix: Electric coolant pump for hybrid inverter fails—impeller wears or motor burns out. Pump sits under rear seat/cargo area. 3-4 hours labor, pump is $300-500 OE. If inverter overheated before shutdown, may need inverter rebuild ($2,000-3,500). Prevent by flushing hybrid coolant every 100k.
Estimated cost: $800-1,200 pump only

Steering Intermediate Shaft Clunk

Occasional · low severity
Typical onset: 70,000-110,000 mi
Symptoms: Clunk or knock felt in steering wheel when turning at low speed, Noise from base of steering column, No effect on steering function
Fix: U-joint in intermediate shaft between column and rack wears or loses grease. Toyota issued TSB but no recall. Replacement shaft 1.5-2 hours labor. Aftermarket shafts often re-introduce noise; OE Toyota part recommended.
Estimated cost: $300-500
Owner tips
  • If buying a 2.7L I4, check oil consumption NOW—run it hard, check dipstick after 500 miles. Walk away if it's burning oil.
  • Inspect transmission cooler lines annually in rust-belt states; catch corrosion early before a full fluid loss.
  • Hybrid models: flush pink inverter coolant at 100k to save the inverter pump; it's cheap insurance.
  • 3.5L V6 is the sweet spot—most power, best reliability, none of the 2.7L oil consumption nightmare.
Buy the 3.5L V6 or Hybrid without hesitation; avoid the 2.7L I4 entirely unless oil consumption has been documented as normal.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
473 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →