2016 CHEVROLET COLORADO

2.5L I44WDAUTOMATICgas
5-Year Cost of Ownership
$15,180 maintenance + known platform issues
~$3,036/yr · 250¢/mile equivalent · $5,159 maintenance + $8,821 expected platform issues
Compare this engine
vs
2.7L I4 Turbo
vs
2.8L I4 Duramax Diesel
vs
3.6L V6
Common Problems & Known Issues

The 2016 Colorado is a capable mid-size truck, but the 2.8L Duramax diesel suffers catastrophic engine failures due to crankshaft bearing defects, while the gasoline engines are generally solid. Transmission cooler line leaks are common across all powertrains.

2.8L Duramax Crankshaft Bearing Failure (Catastrophic Engine Failure)

Common · high severity
Typical onset: 60,000-120,000 mi
Symptoms: Sudden metallic knocking from engine, Oil pressure warning light, Complete engine seizure without warning, Metal shavings in oil filter during regular changes
Fix: Crankshaft main bearings fail prematurely, often taking out the crank, block, pistons, and rods. Requires complete engine replacement or full rebuild with updated bearings. 18-25 labor hours for shortblock or longblock R&R. GM issued TSB 18-NA-355 but no recall. Some engines fail twice.
Estimated cost: $8,000-15,000

Transmission Oil Cooler Line Leaks

Common · medium severity
Typical onset: 40,000-90,000 mi
Symptoms: Transmission fluid puddles under vehicle near radiator, Low transmission fluid warning, Burnt transmission fluid smell, Slipping shifts if fluid level drops significantly
Fix: Steel cooler lines corrode at crimped fittings or develop pinhole leaks. Lines run along frame rail and get road salt exposure. Replace both lines preventatively when one fails. 2-3 labor hours, requires dropping exhaust on some configurations.
Estimated cost: $400-700

Rear Transmission Mount Failure

Occasional · medium severity
Typical onset: 60,000-100,000 mi
Symptoms: Clunking when shifting from park to drive, Vibration at highway speeds, Driveline shudder on acceleration, Visible torn rubber on mount during inspection
Fix: Rubber isolator separates or tears, especially on 4WD models with heavier driveline loads. Allows excessive drivetrain movement. 1.5-2 labor hours, must support transmission during replacement.
Estimated cost: $250-450

2.8L Duramax Diesel Particulate Filter Clogging (Short Trip Trucks)

Occasional · medium severity
Symptoms: Reduced power / limp mode, DPF regeneration cycle runs constantly, Excessive fuel consumption, Check engine light with P2002 or P244A codes
Fix: Trucks driven primarily short distances don't reach temperatures needed for passive regeneration. DPF clogs with soot. Forced regeneration via scan tool often resolves early cases (0.5 hours). Severely clogged filters need removal and cleaning ($600-900) or replacement. 3-4 hours labor for DPF replacement.
Estimated cost: $150-2,200

2.5L I4 Valve Cover Gasket Leaks

Occasional · low severity
Typical onset: 70,000-110,000 mi
Symptoms: Oil seepage visible on valve cover perimeter, Burning oil smell from engine bay, Oil drops on driveway (minor), Low oil level between changes
Fix: Rubber gasket hardens and leaks, especially on passenger side. Oil drips onto exhaust causing smell. Simple replacement job. 1.5-2 labor hours.
Estimated cost: $200-350

Fuel Pump Failure (Gasoline Models - Recall Related)

Occasional · high severity
Symptoms: No-start condition, Intermittent stalling while driving, Engine cranks but won't fire, Fuel pump whine disappears when key turned on
Fix: In-tank fuel pump fails suddenly. Covered under NHTSA recall 18V-355 for certain VINs. Even non-recall pumps fail at similar rates. 2-3 labor hours, must drop fuel tank. Check recall status by VIN before paying out of pocket.
Estimated cost: $600-1,000

Tailgate Latch Failure

Occasional · low severity
Typical onset: 50,000-120,000 mi
Symptoms: Tailgate won't latch closed, Tailgate drops open while driving, Latch mechanism feels loose or doesn't engage, Rattling from tailgate area
Fix: Plastic latch components wear or break, tailgate won't secure. Covered under recall 16V-723 for some VINs. Aftermarket latches available. 1 labor hour replacement.
Estimated cost: $150-300
Owner tips
  • 2.8L Duramax owners: send oil samples to lab every oil change starting at 50k miles to catch bearing wear early — catching metal before catastrophic failure can save the engine
  • Avoid 2.8L diesel entirely if buying used unless engine has already been replaced under warranty with updated parts
  • Inspect transmission cooler lines annually in salt states; cheap insurance versus a $4,000 transmission replacement from running dry
  • Diesel trucks need highway miles — if your use case is under 10 miles per trip, buy the 3.6L V6 instead to avoid DPF issues
Buy the 3.6L V6 version used with confidence; avoid the 2.8L Duramax unless you enjoy gambling with five-figure engine replacements.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
520 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →