Back to search

2018 MITSUBISHI OUTLANDER

2.4L I4•AWD•CVT•gas
5-Year Cost of Ownership
$13,184 maintenance + known platform issues
~$2,637/yr · 220¢/mile equivalent · $5,159 maintenance + $7,190 expected platform issues
Compare this engine
vs
2.0L I4
vs
2.5L I4
vs
3.0L V6
Common Problems & Known Issues

The 2018 Outlander is a budget-oriented crossover with a mixed reliability record. The CVT transmission and 2.4L engine have known weak points that lead to catastrophic failures, often outside warranty coverage.

CVT Transmission Failure (Jatco CVT8)

Common · high severity
Typical onset: 60,000-120,000 mi
Symptoms: Shuddering or jerking during acceleration, especially from stop, Whining or grinding noise during operation, Hesitation when shifting into gear, CVT fluid burning smell, Complete loss of forward movement
Fix: CVT replacement or rebuild required. Most failures stem from inadequate cooling and fluid degradation. Remanufactured CVT swap takes 8-12 hours. Many shops won't rebuild these due to poor longevity of internal components. Fluid changes every 30k can delay but not prevent failure.
Estimated cost: $4,500-7,500

2.4L Engine Piston and Ring Failure

Occasional · high severity
Typical onset: 80,000-140,000 mi
Symptoms: Excessive oil consumption (1 quart per 1,000 miles or worse), Blue smoke from exhaust on startup or acceleration, Misfires and rough idle, Knocking or ticking noise from engine, Loss of power under load
Fix: Ring land failure on pistons is the root cause—piston #2 and #3 most common. Requires engine rebuild with updated pistons or short block replacement. 18-24 hours labor for complete teardown. Some owners report issues as early as 50k miles. This is a design flaw, not maintenance-related.
Estimated cost: $5,000-8,000

Transmission Oil Cooler Line Leaks

Common · medium severity
Typical onset: 50,000-90,000 mi
Symptoms: Red fluid puddles under vehicle, Low transmission fluid warning light, Transmission overheating warnings, CVT slipping or delayed engagement
Fix: Crimped connections on factory cooler lines crack and leak. Must replace both feed and return lines—don't attempt to patch. 2-3 hours labor including fluid refill. Critical to catch early; running CVT low on fluid accelerates catastrophic failure. Inspect lines during every oil change on these.
Estimated cost: $400-700

Front Engine Mount Failure

Common · low severity
Typical onset: 60,000-100,000 mi
Symptoms: Excessive vibration at idle, especially in Drive, Clunking when accelerating or braking, Engine movement visible from engine bay, Steering wheel shake
Fix: Hydraulic engine mount (driver's side) separates internally. Rubber degrades and fluid leaks out. Replace the mount—aftermarket units acceptable but OE lasts longer. 1.5-2 hours labor. Often mistaken for CVT issues due to vibration profile.
Estimated cost: $250-450

Rear Liftgate Strut Failure

Occasional · low severity
Symptoms: Liftgate won't stay open or falls suddenly, Slow or weak opening motion, One side opens slower than the other
Fix: Factory struts lose gas charge prematurely—subject to two NHTSA recalls but failures continue post-recall. Replace both struts as a pair (one weak strut overloads the other). 0.5 hours labor. Check for updated part numbers; early replacements also failed.
Estimated cost: $150-300

Forward Collision Mitigation False Activation

Occasional · medium severity
Symptoms: Unexpected emergency braking on clear roads, FCM warning light flashing intermittently, System activates in rain, snow, or bright sunlight, Radar sensor errors on display
Fix: Radar module behind front bumper cover miscalibrates or gets confused by reflections. Software update (TSB 18-54-001) addresses some cases. If persistent, radar module replacement required. 2 hours labor including calibration. Recall 19V-397 covers some VINs—check before paying out of pocket.
Estimated cost: $800-1,200
Owner tips
  • Change CVT fluid every 30,000 miles with Mitsubishi Diaqueen fluid—not lifetime despite manual claim
  • Check transmission cooler lines for seepage at every service; early catch prevents CVT damage
  • Monitor oil consumption closely on 2.4L engines; burn over 1 qt per 3,000 mi signals impending failure
  • Avoid extended idling and heavy towing; CVT cooling is marginal and engine oil temps climb rapidly
Hard pass unless under 40k miles with extended warranty coverage—CVT and engine failures are expensive and common enough to make this a risky used buy.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
498 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →