P1151high severityPowertrain
Accelerator Pedal Position Sensor 2 Circuit Malfunction
on 2017 Kia Forte 2.0L I4 · FWD
What this code means
The PCM has detected a malfunction in the Accelerator Pedal Position Sensor 2 circuit. This redundant sensor provides a backup throttle demand signal for safety. A fault in either APP sensor triggers reduced power mode.
Symptoms
- Check Engine Light
- Reduced power mode activated
- Engine limited to low RPM
- ETC warning light on
- Slow throttle response
Common causes
- Faulty APP sensor 2
- Wiring or connector issue in APP sensor 2 circuit
- Corroded accelerator pedal connector
- Failing accelerator pedal assembly
- Reference voltage issue
Diagnostic steps
- Monitor APP sensor 2 voltage through full pedal travel
- Compare APP sensor 2 with APP sensor 1 readings
- Inspect accelerator pedal connector for corrosion
- Check reference voltage at APP sensor 2
- Wiggle test wiring while monitoring
Repair notes
Replace the accelerator pedal assembly if the APP sensor 2 is faulty.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1