1995 CHRYSLER CONCORDE

3.5L V6FWDAUTOMATICgas
5-Year Cost of Ownership
$54,089 maintenance + known platform issues
~$10,818/yr · 900¢/mile equivalent · $32,383 maintenance + $5,256 expected platform issues
Compare this engine
vs
2.7L V6
vs
3.2L V6
Common Problems & Known Issues

The 1995 Chrysler Concorde rides on Chrysler's LH platform with the Ultradrive automatic transmission — a problematic pairing that defines ownership. Both the 3.3L and 3.5L V6 engines suffer from severe head gasket and internal engine failures at relatively low mileage, making this a high-risk used purchase.

Catastrophic Head Gasket Failure (3.3L and 3.5L)

Common · high severity
Typical onset: 80,000-140,000 mi
Symptoms: White smoke from exhaust, especially on cold start, Overheating with no external coolant leaks, Milky oil on dipstick or oil cap, Loss of coolant with no visible puddles, Rough idle and misfires after warm-up
Fix: Both head gaskets require removal of intake manifold, exhaust manifolds, timing components. Machine shop resurface mandatory. Expect 14-18 labor hours if no additional damage. If coolant contaminated oil, internal bearings often damaged requiring full teardown.
Estimated cost: $2,200-3,800

41TE Ultradrive Transmission Failure

Common · high severity
Typical onset: 90,000-130,000 mi
Symptoms: Delayed engagement into Drive or Reverse (2-3 seconds), Hard or erratic shifting between 2nd and 3rd gears, Slipping under acceleration, especially uphill, Transmission overheating, burnt fluid smell, Check Engine light with transmission-related codes
Fix: The 41TE has weak solenoid packs, governor pressure issues, and overheating tendencies. Rebuild requires 10-14 hours; most shops recommend replacement with remanufactured unit due to case wear and valve body scoring. Fluid changes every 30k can delay but not prevent failure.
Estimated cost: $2,800-4,200

Lower Control Arm Bushing and Ball Joint Failure

Common · medium severity
Typical onset: 70,000-110,000 mi
Symptoms: Clunking over bumps from front suspension, Steering wander and poor return to center, Uneven inner tire wear, Vibration through steering wheel at highway speeds, Knocking sound during turns
Fix: Front lower control arms have press-in bushings and ball joints that fail together. Most techs replace entire control arm assemblies rather than pressing bushings. NHTSA recall covered some VINs but not all. Plan 3-4 hours per side including alignment.
Estimated cost: $600-1,100

Intake Manifold Plenum Gasket Leak (3.3L/3.5L)

Occasional · medium severity
Typical onset: 60,000-100,000 mi
Symptoms: Rough idle and stalling when cold, Whistling or hissing sound from engine bay, P0171/P0174 lean codes, Poor fuel economy (3-5 mpg drop), Hesitation during acceleration
Fix: Upper intake plenum gasket deteriorates causing vacuum leaks. Requires removal of upper plenum, throttle body, and EGR components. Straightforward 4-5 hour job. Replace all vacuum lines while you're in there as they're equally aged and brittle.
Estimated cost: $450-750

Crankshaft Position Sensor Failure

Occasional · high severity
Symptoms: No-start condition with cranking but no ignition, Stalling at idle or while driving with no warning, Intermittent stalling that worsens when engine is hot, Check Engine light with P0320 code, Car dies and restarts after cooling 20-30 minutes
Fix: Located on transmission bellhousing behind engine. Heat causes internal failure. Requires raising vehicle, removing starter or working around it. 1.5-2.5 hours depending on accessibility. Always replace with OE Mopar sensor — aftermarket failures within months are common.
Estimated cost: $180-350

Power Steering Pump and High-Pressure Hose Leaks

Occasional · low severity
Typical onset: 80,000-120,000 mi
Symptoms: Power steering fluid pooling under vehicle, Groaning or whining during steering input, Intermittent heavy steering, especially when cold, Fluid spray visible on engine bay components, Low fluid level requiring frequent top-offs
Fix: High-pressure hose develops leaks at crimp fittings; pump develops seal leaks. Hose replacement is 1-1.5 hours; pump is 2-3 hours. If caught early, prevents pump damage. Use ATF+4 only — standard power steering fluid damages seals.
Estimated cost: $350-650
Owner tips
  • Change transmission fluid and filter every 30,000 miles with ATF+4 only — extends Ultradrive life but won't prevent eventual failure
  • Monitor coolant level weekly; sudden drops indicate head gasket failure starting
  • Replace timing belt and water pump at 90,000 miles even though these are non-interference engines — water pump failure causes overheating which kills head gaskets
  • Carry a spare crankshaft position sensor in the trunk — it's a common roadside breakdown
Hard pass unless free — the combination of inevitable transmission failure and engine internal problems makes this a money pit that will strand you.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
591 jobs across 17 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →