2004 CHRYSLER CONCORDE

3.2L V6FWDAUTOMATICgas
5-Year Cost of Ownership
$41,293 maintenance + known platform issues
~$8,259/yr · 690¢/mile equivalent · $32,383 maintenance + $8,210 expected platform issues
Compare this engine
vs
2.7L V6
vs
3.5L V6
Common Problems & Known Issues

The 2004 Concorde is a comfortable highway cruiser plagued by catastrophic 2.7L engine failures and transmission issues. The 2.7L V6 is notorious for oil sludging that destroys engines, while transmission cooler failures can take out both the trans and engine simultaneously.

2.7L V6 Oil Sludge and Catastrophic Engine Failure

Common · high severity
Typical onset: 80,000-150,000 mi
Symptoms: engine oil light flickering or staying on, knocking/ticking from valvetrain, sudden loss of oil pressure, complete engine seizure without warning, milky oil cap residue
Fix: The 2.7L has inadequate oil drainage from the heads and poor PCV design that causes sludge buildup, starving bearings and camshafts. Once knocking starts, it's too late—requires complete engine replacement or rebuild. 16-24 hours labor for used engine swap, 30-40 hours for full rebuild with machine work.
Estimated cost: $3,500-6,500

Transmission Oil Cooler Failure (Internal to Radiator)

Common · high severity
Typical onset: 90,000-130,000 mi
Symptoms: transmission slipping or delayed engagement, milky pink fluid in coolant reservoir, milky red fluid on dipstick, overheating transmission and engine simultaneously, sudden loss of forward gears
Fix: The cooler inside the radiator develops pinhole leaks, mixing coolant with ATF. Coolant in trans destroys clutch packs and seals within days. Requires radiator replacement, trans flush, often full transmission rebuild if driven after contamination. External cooler installation recommended. 12-20 hours labor depending on trans damage.
Estimated cost: $2,800-5,200

42LE Transmission Overdrive and Solenoid Pack Failures

Common · medium severity
Typical onset: 100,000-140,000 mi
Symptoms: no overdrive/stuck in 3rd gear, harsh 2-3 or 3-4 shifts, check engine light with trans codes, delayed engagement when cold, slipping between gears on highway
Fix: The solenoid pack and overdrive clutches wear out from heat and contaminated fluid. Often misdiagnosed as needing full rebuild when solenoid pack replacement ($600-900 parts/labor) fixes it. If clutches are burnt, needs full rebuild. Drop pan, inspect clutch material in fluid first. 8-14 hours for rebuild.
Estimated cost: $600-3,200

Engine Mount Collapse (Front and Rear)

Common · low severity
Typical onset: 70,000-110,000 mi
Symptoms: heavy clunk when shifting from Park to Drive, engine rocking visible from driver seat on acceleration, vibration at idle that improves with RPM, transmission linkage feeling loose or imprecise
Fix: Hydraulic mounts fail internally, causing excessive drivetrain movement. Front mount is most common, but rear trans mount also collapses. Replace all three mounts at once to avoid comeback. 3-4 hours labor for all mounts.
Estimated cost: $450-750

Intake Manifold Gasket Leaks (3.5L V6)

Occasional · medium severity
Typical onset: 90,000-140,000 mi
Symptoms: coolant smell from engine bay, slow coolant loss with no visible leaks, rough idle when cold, minor misfire codes on multiple cylinders, coolant residue on lower intake plenum
Fix: The lower intake manifold gaskets deteriorate and leak coolant into the valley or externally. Can cause cylinder washing if ignored. Upper plenum removal required for access. 5-7 hours labor, straightforward job.
Estimated cost: $650-1,100

Alternator Failure and Battery Drain Issues

Occasional · medium severity
Typical onset: 80,000-120,000 mi
Symptoms: battery light flickering at idle, dimming headlights with accessories on, dead battery after overnight parking, voltage gauge reading low (under 13V running), whining noise from alternator pulley area
Fix: Alternators fail from heat and age, often the voltage regulator internally. Also common: parasitic draw from failing body control module or interior light circuits staying on. Test charging system first, then check for draws. Alternator replacement 1.5-2 hours labor.
Estimated cost: $350-650

Front Strut Mount Bearing Failure

Occasional · low severity
Typical onset: 80,000-120,000 mi
Symptoms: clunking from front suspension over bumps, popping noise when turning steering wheel while stopped, steering not returning to center smoothly, uneven tire wear on front inside edges
Fix: The top strut mount bearings seize or break apart. Often misdiagnosed as needing full struts when just mounts are bad. Replace mounts and perform alignment. If struts are original, replace assembly together. 3-4 hours labor for both sides with alignment.
Estimated cost: $550-900
Owner tips
  • If buying a 2.7L model, walk away unless engine has been replaced—no amount of maintenance fixes the sludge design flaw
  • Check coolant reservoir for any pink tint and trans fluid for milky appearance—evidence of the killer radiator cooler leak
  • Change transmission fluid every 30,000 miles with Mopar ATF+4 only, install external cooler if towing or hot climate
  • The 3.5L V6 is significantly more reliable than the 2.7L—seek that engine if buying used
  • Check for evidence of intake gasket leaks on 3.5L by inspecting the valley area with a flashlight during oil changes
Avoid the 2.7L engine entirely; a 3.5L model with service records under 100k miles can be a decent value, but budget $2-3k for likely transmission work.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
591 jobs across 17 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →