2001–2010 CHRYSLER SEBRING

2.7L V6FWDAUTOMATICgas
5-Year Cost of Ownership
$55,033 maintenance + known platform issues
~$11,007/yr · 920¢/mile equivalent · $31,743 maintenance + $6,090 expected platform issues
Compare this engine
vs
2.4L I4 World Engine
vs
3.5L V6
Common Problems & Known Issues

The 2001-2010 Chrysler Sebring with the 2.7L V6 is notorious for catastrophic engine failures and transmission cooling system problems. These vehicles frequently require major powertrain work well before 150,000 miles, making them risky used purchases.

2.7L V6 Sludge Buildup and Catastrophic Engine Failure

Common · high severity
Typical onset: 80,000-130,000 mi
Symptoms: Oil pressure warning light flickering or staying on, Knocking or ticking noises from engine, especially on cold starts, Sudden loss of power or complete engine seizure, Excessive oil consumption between changes
Fix: The 2.7L has inadequate oil passages that clog with sludge even with regular maintenance. Once it starts knocking, you're looking at complete engine replacement or rebuild. Typical rebuild is 25-35 labor hours including head work, new bearings, rings, timing components. Many shops won't touch them—recommend reman long block instead.
Estimated cost: $4,500-7,500

Transmission Oil Cooler Line Failure and Cross-Contamination

Common · high severity
Typical onset: 60,000-100,000 mi
Symptoms: Pink milky substance in coolant reservoir (coolant in trans fluid), Transmission slipping or delayed engagement, Engine overheating with transmission damage, Coolant loss without external leaks
Fix: The internal transmission cooler inside the radiator fails, allowing coolant and trans fluid to mix. This destroys the transmission rapidly. Proper fix requires new radiator with external cooler bypassing internal one, complete transmission flush or rebuild if contaminated, and all cooler lines. If caught early (just cooler line), 4-6 hours. If trans is damaged, add 12-18 hours for rebuild.
Estimated cost: $800-1,200 (caught early) or $3,000-5,000 (with transmission damage)

Timing Chain Tensioner and Guide Failure

Occasional · high severity
Typical onset: 100,000-150,000 mi
Symptoms: Rattling noise from front of engine on startup that quiets after few seconds, Check engine light with cam/crank correlation codes, Rough idle or misfires, Catastrophic failure results in bent valves
Fix: The 2.7L timing chain system uses plastic guides and weak tensioners. When they fail, chain slaps around and can jump time. Requires front engine disassembly, new chains, guides, tensioners, gears, and usually water pump while in there. 12-16 hours labor. If it jumps time, add valve job—another 8-12 hours and head work.
Estimated cost: $2,000-3,200 (preventive) or $4,500-6,500 (with valve damage)

Lower Engine Mount (Transmission Mount) Failure

Common · medium severity
Typical onset: 50,000-90,000 mi
Symptoms: Excessive vibration at idle in gear, Clunking when shifting from park to drive or reverse, Engine rocks forward noticeably during acceleration, Transmission linkage feels notchy or imprecise
Fix: The lower dogbone mount deteriorates and tears, allowing excessive powertrain movement. Common failure point on this platform. Requires lifting engine slightly for access. 2-3 hours labor with alignment of drivetrain afterward to prevent vibration.
Estimated cost: $300-500

Evaporative Emissions System Leaks

Common · low severity
Typical onset: 70,000-120,000 mi
Symptoms: Check engine light with P0455 or P0456 EVAP leak codes, Fuel smell near rear of vehicle or inside cabin, Difficulty filling gas tank (pump clicks off repeatedly), Hissing sound from fuel tank area after shutting off
Fix: Multiple EVAP system components fail on these—purge valve, vent valve, leak detection pump, and commonly the fuel tank itself cracks at the seams. Diagnosis with smoke machine is essential. Purge valve alone is 1 hour, fuel tank replacement is 3-4 hours including dropping tank and transferring pump assembly.
Estimated cost: $200-400 (valves) or $800-1,400 (fuel tank)

Front Suspension Strut Mount Bearing Failure

Occasional · medium severity
Typical onset: 60,000-100,000 mi
Symptoms: Clunking noise over bumps from front corners, Steering doesn't return to center smoothly, Creaking or groaning when turning wheel while stationary, Uneven tire wear on front tires
Fix: The strut mount bearings seize or break apart, causing noise and poor handling. Often replaced with struts as an assembly for alignment purposes. Strut mounts alone are 2-3 hours, but if struts are weak (usually are at this mileage), do complete strut assemblies—4-5 hours plus alignment.
Estimated cost: $400-600 (mounts only) or $800-1,200 (full strut assemblies)
Owner tips
  • Change oil every 3,000-4,000 miles with quality synthetic on the 2.7L—it won't prevent sludge entirely but may delay it
  • Install external transmission cooler and bypass the radiator's internal cooler immediately on purchase—$300 insurance policy
  • Check coolant and transmission fluid color at every oil change for any signs of cross-contamination
  • Budget $500/year minimum for unexpected repairs—these vehicles nickel-and-dime constantly after 80k miles
  • If timing chain starts making noise, park it and fix immediately—catastrophic failure happens fast
Hard pass for most buyers—the 2.7L engine is a ticking time bomb and transmission cooler failure is nearly guaranteed. Only consider if under $2,000 and you're comfortable with eventual $5k+ engine replacement.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
593 jobs across 17 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →