1996 DODGE STEALTH

3.0L V6 DOHCAWDAUTOMATICgas
5-Year Cost of Ownership
$35,149 maintenance + known platform issues
~$7,030/yr · 590¢/mile equivalent · $5,649 maintenance + $9,550 expected platform issues
Compare this engine
vs
3.0L V6 DOHC
vs
3.0L V6 SOHC
vs
3.0L V6 Twin Turbo
Common Problems & Known Issues

The 1996 Dodge Stealth (rebadged Mitsubishi 3000GT) is a complex sports car with AWD and twin-turbo variants that suffer from heat-related engine failures, transmission cooler leaks, and expensive drivetrain repairs. The platform's tight engine bay and labor-intensive design make even routine repairs costly.

Crankshaft Walk / Thrust Bearing Failure (Twin Turbo)

Common · high severity
Typical onset: 60,000-100,000 mi
Symptoms: Metallic grinding or knocking from engine bay, especially during throttle transitions, Check engine light with crank position sensor codes, Severe cases: catastrophic engine failure with oil loss and metal shavings in oil
Fix: Requires engine removal and complete disassembly to replace thrust bearings and machine crankshaft if scored. Expect 25-35 hours labor due to tight bay and AWD/turbo complexity. Many shops recommend full engine rebuild at this point since you're already in there.
Estimated cost: $4,500-8,000

Transmission Oil Cooler Line Failure

Common · high severity
Typical onset: 70,000-120,000 mi
Symptoms: Transmission fluid leaking from front of vehicle near radiator, Pink or red fluid mixing with coolant in overflow tank, Transmission slipping or delayed engagement after leak begins, Overheating transmission in hot weather or under load
Fix: Steel cooler lines corrode and rupture where they connect to radiator or run along frame rails. Replacement requires dropping front crossmember on AWD models. If fluid mixed into coolant, transmission flush is mandatory. 6-10 hours labor depending on AWD/FWD.
Estimated cost: $800-1,500

Head Gasket Failure (Both Banks)

Occasional · high severity
Typical onset: 80,000-140,000 mi
Symptoms: White smoke from exhaust on cold start, Coolant loss with no visible external leaks, Milky oil on dipstick or under oil cap, Rough idle and misfires on affected cylinder bank
Fix: The transverse V6 layout makes this a nightmare job requiring intake manifold, turbos (if equipped), timing belt, and extensive accessory removal. Both banks typically done together. 18-28 hours labor. Must resurface heads and replace timing components while apart.
Estimated cost: $3,500-6,000

Transfer Case Viscous Coupling Failure (AWD)

Occasional · medium severity
Typical onset: 90,000-150,000 mi
Symptoms: Binding or hopping when making tight turns at low speed, Clunking from center of vehicle during acceleration, Drivetrain vibration at highway speeds, In severe cases: complete loss of rear-wheel drive power
Fix: The viscous coupling unit in the transfer case wears out and can seize. Transfer case removal requires exhaust, driveshaft work, and transaxle separation. Used units are getting scarce. 12-16 hours labor. Note: this was subject to NHTSA recall but many were never addressed.
Estimated cost: $2,200-3,800

Turbocharger Failure and Oil Line Issues (Twin Turbo)

Occasional · medium severity
Typical onset: 80,000-120,000 mi
Symptoms: Blue smoke on acceleration or deceleration, Whistling or grinding noise from engine bay under boost, Loss of boost pressure and sluggish acceleration, Oil consumption increases noticeably (1 qt per 500-1000 miles)
Fix: Turbos fail from age, heat cycling, and oil starvation from clogged feed lines. Access requires removing intake plenum and intercooler piping. Factory oil feed lines crack. Smart shops replace both turbos and all oil lines together. 14-18 hours for both turbos plus lines.
Estimated cost: $2,800-4,500

Engine and Transmission Mounts Deterioration

Common · low severity
Typical onset: 60,000-100,000 mi
Symptoms: Excessive engine movement visible when revving in park, Clunking when shifting from reverse to drive, Vibration through chassis at idle, Transmission shifter feels loose or vague
Fix: Hydraulic mounts wear out and cause driveline slop. Front mount accessible but rear requires significant disassembly. Transmission mount needs subframe support. All three typically done together. 5-8 hours labor.
Estimated cost: $900-1,400
Owner tips
  • Change timing belt every 60k miles religiously—interference engine will destroy itself if belt fails
  • Use quality synthetic oil and change every 3-4k miles on turbos to prevent crank walk and turbo failure
  • Flush transmission fluid every 30k miles and address cooler line rust early—transmission replacement is $4k+
  • Budget $1,500-2,000 annually for deferred maintenance on any used example—these cars were neglected
  • Avoid modded or abused examples—stock turbos already stress the bottom end at factory boost levels
Only buy if you're handy with tools and have $3-5k set aside for immediate engine/trans work—these are spectacular cars when sorted, but most examples are ticking time bombs from deferred maintenance and known platform weaknesses.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
514 jobs across 15 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →