The 2013 F-250 Super Duty runs two very different powertrains: the bulletproof 6.2L gas V8 and the problematic 6.7L Power Stroke diesel that suffers catastrophic failures tied to defective casting issues in early build years. The 6R140 transmission has a cooling system weakness that can grenade the unit if ignored.
6.7L Power Stroke Catastrophic Engine Failure (Piston/Bearing/Block)
Occasional · high severityTypical onset: 80,000-150,000 mi
Symptoms: Sudden knocking or rattling from deep in the engine, often at cold start, Metal shavings in oil during routine changes, Loss of power under load, white or blue smoke, Check engine light with misfire or low oil pressure codes
Fix: Early 6.7L engines (2011-2014) have a documented issue with porous engine block castings and weak piston skirts. Connecting rod bearings spin, pistons crack, or blocks crack internally. This requires complete short block replacement or full engine rebuild with updated parts. 30-50 hours labor depending on cab-on vs cab-off repair, plus core exchange and updated engine assembly.
Estimated cost: $15,000-25,000
Transmission Oil Cooler Failure (6R140)
Common · high severityTypical onset: 60,000-120,000 mi
Symptoms: Transmission fluid in coolant (strawberry milkshake in overflow tank), Coolant in transmission (slipping, erratic shifts, won't move), Overheating transmission or engine temp spikes
Fix: The internal transmission cooler in the radiator fails and allows cross-contamination. Once fluids mix, the transmission is often damaged and requires rebuild or replacement. Fix requires new radiator, complete transmission fluid system flush (or full rebuild if contaminated), torque converter, and sometimes hard lines. 12-20 hours if trans needs rebuild, 4-6 hours if caught early with flush only.
Estimated cost: $3,500-8,000
6.7L Diesel Fuel System Contamination/Filter Clogging
Common · medium severitySymptoms: Hard starting or extended cranking, especially in cold weather, Loss of power, rough idle, stalling, Check engine light with fuel pressure/rail pressure codes, Black smoke under acceleration
Fix: The 6.7L is extremely sensitive to fuel quality and water contamination. Clogged fuel filters are frequent (should be changed every 10k-15k mi), but contaminated fuel can damage the high-pressure fuel pump and injectors. If caught at the filter stage, it's a 1-hour job. If injectors or CP4 pump fail from contamination, you're looking at 8-15 hours for injector replacement or pump R&R with full system flushing.
Estimated cost: $150-6,500
EGR Cooler Failure (6.7L Diesel)
Occasional · high severityTypical onset: 100,000-180,000 mi
Symptoms: White smoke from exhaust constantly (not just cold start), Coolant loss with no external leaks, Overheating or temperature fluctuations, Rough running, loss of power, coolant smell from exhaust
Fix: The EGR cooler cracks internally and dumps coolant into the intake and exhaust. This can cause hydrolock and bent rods if enough coolant accumulates. Requires EGR cooler replacement, often with full EGR valve and sensors. Also recommend oil and coolant analysis to check for engine damage. 6-10 hours labor depending on accessibility and whether you do EGR delete or OEM replacement.
Estimated cost: $2,000-3,500
Transmission Mount Failure
Common · low severityTypical onset: 80,000-140,000 mi
Symptoms: Clunking or banging when shifting from park to drive/reverse, Vibration through cab at idle or under throttle, Visible sag or torn rubber on crossmember mount
Fix: The rubber transmission mount deteriorates from heat and load, especially on diesels and trucks that tow heavy. Simple replacement: drop the crossmember, swap the mount. 1.5-2.5 hours labor, often done alongside other trans work.
Estimated cost: $250-500
Turbocharger Failure (6.7L Diesel)
Occasional · high severityTypical onset: 120,000-200,000 mi
Symptoms: Loss of boost/power under load, Loud whining or whistling noise from engine bay, Blue or black smoke from exhaust, Oil leaking from turbo or intake piping, Check engine light with boost pressure codes
Fix: Turbo failures stem from oil contamination (usually from the notorious CP4 fuel pump failure sending metal through the system), failed bearings, or wastegate actuator issues. Variable-vane turbos on the 6.7L are expensive. Replacement involves removing exhaust components, downpipe, and intercooler piping. 8-12 hours labor with new or reman turbo.
Estimated cost: $2,500-4,500
Buy the 6.2L gas without hesitation; avoid 2011-2014 6.7L diesels unless engine has been replaced under warranty or you have $20k set aside for when it grenades.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.