P3036moderate severityPowertrain
Wastegate Position Sensor Calibration Error
on 2018 Infiniti Q70L 5.6L V8 · RWD
What this code means
The electronic wastegate position sensor has lost its calibration reference. The PCM cannot accurately determine wastegate valve position.
Symptoms
- Check Engine Light
- Boost control reverts to safe mode
- Conservative boost levels applied
- Turbo response feels inconsistent
- May experience occasional overboost or underboost
Common causes
- Sensor zero-point drift
- Sensor exposed to extreme heat
- Calibration data lost after battery disconnect
- Sensor magnet weakened
- Actuator mechanical play affecting position
Diagnostic steps
- Read wastegate position sensor raw values
- Perform sensor calibration procedure per manufacturer
- Compare commanded vs actual wastegate position
- Check sensor mounting for play
- Inspect sensor for heat damage
Repair notes
Perform wastegate position sensor calibration with manufacturer scan tool. Replace sensor if calibration procedure fails.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1