P1401moderate severityPowertrain
DPFE Sensor Circuit High Input
on 2012 Mazda CX-7 2.5L I4 · AWD
What this code means
The DPFE sensor circuit is reading above the maximum expected voltage. The sensor is reporting excessive EGR flow or has an electrical fault producing a high reading.
Symptoms
- Check Engine Light
- Rough idle
- Engine surge
- Poor fuel economy
- Knocking or pinging
- Failed emissions test
Common causes
- Faulty DPFE sensor corroded internally
- DPFE sensor hoses reversed
- Clogged EGR metering orifice
- Wiring short to power
- Vacuum leak in EGR system
Diagnostic steps
- Check DPFE sensor voltage at key-on engine-off (should be 0.45-0.55V; above 1V indicates bad sensor)
- Verify DPFE hoses are not reversed
- Inspect EGR metering orifice for blockage
- Check wiring for shorts to power
- Test sensor response to applied vacuum
Repair notes
Replace the DPFE sensor, which is the most common cause; verify hoses are correctly connected.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1