The 2015 BRZ with the FA20 engine is a solid sports car platform, but early production units are notorious for catastrophic engine failure due to valve spring defects and poor RTV sealant application during assembly—issues that plague high-RPM driving and can grenade motors without warning.
Valve Spring / RTV Sealant Engine Failure
Occasional · high severityTypical onset: 60,000-90,000 mi
Symptoms: Sudden loss of power and metal-on-metal noise at high RPM, Oil starvation symptoms—low pressure warning, bearing knock, Coolant/oil mixing if RTV chunks block oil pickup, Catastrophic failure often occurs during spirited driving or track use
Fix: Complete short block or engine replacement required. Early FA20s had weak valve springs that break under sustained high RPM, and excess RTV sealant from factory assembly breaks off and clogs oil pickup screens. 20-30 labor hours for used engine swap, 35-45 hours for full rebuild with upgraded parts.
Estimated cost: $4,500-8,500
Throwout Bearing (TOB) Chatter and Failure
Common · medium severityTypical onset: 40,000-80,000 mi
Symptoms: Grinding or chattering noise when clutch pedal is depressed, Noise worsens in cold weather, Eventually clutch disengagement becomes difficult or impossible, Some owners report noise starting as early as 20,000 miles
Fix: Transmission removal required to replace throwout bearing and often clutch assembly while in there. 8-10 labor hours. Many techs recommend replacing with upgraded bearing and doing clutch, pressure plate, and rear main seal as a package deal.
Estimated cost: $1,200-2,200
Transmission Mount Failure
Common · low severityTypical onset: 50,000-90,000 mi
Symptoms: Excessive drivetrain movement during shifts, Clunking from underneath during acceleration/deceleration, Shifter feel becomes vague or notchy, Increased cabin vibration at idle
Fix: Rear transmission mount bushing deteriorates from engine torque and heat. Accessible from underneath, 1.5-2 hours labor. Many owners upgrade to stiffer aftermarket mounts.
Estimated cost: $200-450
Fuel Pump Failure / Fuel Starvation
Occasional · medium severityTypical onset: 70,000-120,000 mi
Symptoms: Engine stumbling or cutting out during hard cornering (below 1/4 tank), Intermittent no-start conditions, Fuel pump whine audible from rear seats, CEL with lean fuel codes (P0171/P0174)
Fix: Fuel pump assembly replacement requires dropping tank. 3-4 labor hours. The factory fuel basket design is poor for track use—fuel sloshes away from pickup. Some owners install aftermarket baffles.
Estimated cost: $600-1,100
Transmission Oil Cooler Line Leaks
Occasional · medium severityTypical onset: 60,000-100,000 mi
Symptoms: Transmission fluid dripping from front of vehicle, Low fluid causes hard or delayed shifts, Fluid found on subframe or undertray, Burning smell after highway driving
Fix: Cooler lines run along subframe and corrode or crack at crimp points. Line replacement requires lifting vehicle and sometimes subframe drop for access. 2-3 labor hours plus fluid/filter service.
Estimated cost: $400-750
Cricket Chirp / Fuel Pump Resonance
Common · low severitySymptoms: High-pitched chirping or buzzing from rear of cabin at 3,000-4,000 RPM, Noise present since new or low mileage, No performance impact, purely audible annoyance, Resonance frequency varies with fuel pump speed
Fix: This is a fuel pump resonance issue caused by tank/pump bracket design. TSB exists but fixes are hit-or-miss. Some owners add dampening material to tank. Not a reliability concern. 1-2 hours for dampening attempts.
Estimated cost: $0-300
Buy a 2017+ model year if possible—Subaru addressed most FA20 gremlins by then—but a well-maintained 2015 with recall work done and no track abuse can still be a reliable, fun platform if you're prepared for the TOB and mount replacements.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.