2021 PEUGEOT 208

Typical onset: 60,000-100,000 mi

Symptoms: metallic rattling on cold start, milky oil on dipstick, check engine light with cam/crank correlation codes, sudden loss of power or no-start

Fix: The oil-bathed timing belt deteriorates and sheds debris into the oil system, contaminating bearings and oil pump. Requires complete engine teardown or replacement. 12-20 labor hours depending on contamination extent. PSA issued extended warranties in Europe but US-spec cars often aren't covered.

Estimated cost: $4,500-8,000

Typical onset: 40,000-80,000 mi

Symptoms: harsh shifts at low speeds, vibration at idle in Drive, clunking when reversing, torque converter shudder during light acceleration

Fix: The dual-clutch EAT8 software and transmission mount wear are both culprits. Mount replacement is 2-3 hours; transmission reflash is 1 hour but may only temporarily help. Full clutch pack replacement if shudder persists: 8-12 hours.

Estimated cost: $300-600 for mounts; $2,500-4,200 for clutch packs

Typical onset: 50,000-90,000 mi

Symptoms: knocking or thumping over bumps from rear, vague rear-end feel in corners, uneven inner tire wear

Fix: The rear torsion beam uses pressed-in rubber bushings that crack and separate. Requires trailing arm removal and press work or full arm replacement. 3-4 hours per side, often done in pairs.

Estimated cost: $600-1,000 both sides

Typical onset: 50,000-85,000 mi

Symptoms: clicking when turning, grease on inner wheel well, vibration during acceleration

Fix: Factory CV boots tear early, letting water and dirt in. If caught early, reboot is 1.5 hours per side; if joints are damaged, full axle replacement is 2-2.5 hours each. Parts quality varies heavily by supplier.

Estimated cost: $350-600 per side for axles

Typical onset: 60,000-100,000 mi

Symptoms: steering wheel off-center after hitting potholes, clunking during braking, rapid inside tire wear, wandering on highway

Fix: The front lower control arm bushings tear from the mounting ear, allowing arm movement. Entire control arm replacement required (bushings aren't sold separately in practical terms). 2-3 hours per side including alignment.

Estimated cost: $500-800 per side with alignment

Symptoms: reduced power warning, check engine light with P2002 or P2463, excessive regen cycles, fuel smell in cabin during regen

Fix: Short-trip driving prevents proper DPF regen. Forced regen takes 1 hour via scan tool; if crystallized, removal and cleaning is 3-4 hours, replacement is same time. This is usage-pattern dependent, not mileage.

Estimated cost: $150 for forced regen; $800-1,400 for cleaning; $1,800-2,600 for replacement

Typical onset: 70,000-110,000 mi

Symptoms: parking brake won't release, error message on dash, grinding noise when applying parking brake, brake warning light stays on

Fix: The EPB actuator motor or controller fails, sometimes locking the rear brakes on. Module replacement is 2-2.5 hours including calibration with factory scan tool. Aftermarket options are hit-or-miss on coding.

Estimated cost: $800-1,300