P0010moderate severityPowertrain
Intake Camshaft Position Actuator Circuit/Open Bank 1
on 2018 Audi R8 5.2L V10 (Gen 2, 562hp) · AWD
What this code means
The PCM detected a malfunction in the intake camshaft position actuator circuit for Bank 1. The VVT solenoid controls oil flow to the camshaft phaser.
Symptoms
- Check Engine Light
- Rough idle
- Reduced power
- Engine rattle on startup
Common causes
- Faulty VVT solenoid
- Low oil level or dirty oil
- Wiring issue
- Camshaft phaser failure
Diagnostic steps
- Check engine oil level and condition
- Test VVT solenoid resistance
- Inspect wiring to solenoid
- Command solenoid on/off with scan tool
- Check oil pressure
Repair notes
Replace VVT solenoid or repair wiring. Ensure oil is clean and at proper level.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1
P0016
Crankshaft Position/Camshaft Position Correlation Bank 1 Sensor A